How to Install the Hunter 51289 52-Inch Tailwind Ceiling Fan?

[McCooper]

Absolutely! Here's a straightforward guide to installing your Hunter 51289 52-Inch Tailwind with LED light ceiling fan:

1. Safety First: Before you begin, cut off the power supply to the circuit that controls the fan at the circuit breaker or fuse box. This is a crucial safety step.

2. Location Selection: Determine the ideal spot for your fan. If your ceiling is flat, a standard downrod will suffice. For angled or vaulted ceilings, you'll need a longer downrod (available separately) and possibly an Angled Mounting Kit if the angle exceeds 34°.

3. Mounting Bracket Installation: Secure the ceiling bracket using one of two methods: Option 1 involves machine screws (supplied with the outlet box) and washers if you're attaching it to an existing ceiling fan-rated outlet box. Option 2 utilizes wood screws and washers (provided) if you're fastening to a support structure with a suitable electrical outlet box.

4. Downrod Assembly: If using the pre-assembled downrod, remove the setscrew. Route all wires to one side of the downrod's horizontal bar, thread the wires through the downrod, and hand-tighten the downrod. Trim the fan wires as needed, and then firmly tighten the setscrew with pliers.

5. Hanging the Fan: Carefully lift the fan and attach it to the ceiling bracket. Handle the fan by either the fan housing or the downrod to avoid any damage.

6. Wiring the Fan: Connect the wires according to the wiring diagram in the Hunter 51289 manual. Use wire nuts to make secure connections. Remember to ground the fan properly and adhere to all local and national electrical codes.

7. Canopy Attachment: Slide the canopy up and lock it securely into place.

8. Blade Attachment: Attach the blades to the blade iron posts.

9. Light Kit Assembly: Connect the 9-pin plug from the motor housing to the plug in the switch housing area of the light kit assembly. Align the keyhole slots in the light kit assembly with the partially installed screws and turn counterclockwise. Reinstall the saved assembly and tighten all three screws. Secure the switch housing plate using two short light kit assembly screws.

10. Bulb and Glass Installation: Follow the specific instructions in your Hunter 51289 manual for installing the light bulbs and glass.

11. Pull Chain Installation: Attach the pull chains to the fan housing.

12. Testing: Once everything is in place, turn the power back on and test the fan to ensure it is operating correctly.

For the most accurate and detailed instructions, always consult the Hunter 51289 52-Inch Tailwind with LED light Ceiling Fan Instruction Manual. It contains diagrams and specific guidance for your model.