How do I configure the ALCN-792M/ALCN-792MISO Quad Loop Adder Module's binary address using DIP switches?

[SanEllie]

To configure the binary address of your ALCN-792M/ALCN-792MISO Quad Loop Adder Module, follow these steps: First, locate the DIP switches labeled SW1-1 to SW1-8 on the module. These switches control the module's address. Next, understand that each switch represents a binary digit. An ON position signifies an active state (1), and OFF signifies an inactive state (0). Consult the DIP switch settings table in the module's manual. This table provides the correct settings for each address, typically from 1 to 7. Carefully set the DIP switches according to the desired address using the manual as your guide. For instance, to set the address to 2, you would typically set SW1-1 to OFF, SW1-2 to ON, and switches SW1-3 through SW1-8 to OFF. After setting the switches, verify that the DIP switch settings match your desired binary address. Finally, complete the module's installation and wiring as detailed in the Network Fire Alarm Manual. By correctly setting the DIP switches, you ensure the ALCN-792M/ALCN-792MISO Quad Loop Adder Module functions correctly within your fire alarm system.