How do I install and connect the PROWIFI-EU Wireless Communication Module to my PRO Series Control Panel?

[BrynleeRose]

To successfully connect your PROWIFI-EU Wireless Communication Module to your PRO Series Control Panel, follow these steps: First, always ensure the control panel is completely powered down before beginning. If the panel is active, disarm the system and wait 30-60 seconds. Then, remove the front cover. Next, unplug the Power Supply DC connector and disconnect the battery cables. Now, insert the PROWIFI-EU module into the designated slot on the left side of the control panel, ensuring it is firmly seated on the edge connector. Secure the module using the provided hardware (xxxx). If no other modules are being installed, reconnect the Power Supply DC connector and the battery cables. Replace the control panel front cover and secure it (xxxx). For programming, you'll need a router and an active internet connection for Wi-Fi. Consult your Control Panel's Installation Instructions for detailed programming steps. Module and Z-Wave device configuration are managed via the AlarmNet 360™ cloud-based platform. Remember to enroll the keypad in the Control Panel before use. Finally, after completing the programming, perform a Communications Test to verify proper functionality. By carefully following these steps and referring to your control panel's manual, you can easily integrate your PROWIFI-EU module for enhanced connectivity.