Need help installing the Moen TS3302BL Digital Shower Controller

[DiAlivia]

Absolutely! Here's how to install your Moen TS3302BL Digital Shower Controller, providing step-by-step guidance:

1. Plan the Controller Location: Decide where the controller will be and measure the distance to the valve, allowing for slack in the 30-foot data cable. Remember to create a drip loop at the shower valve connection.
2. Surface Preparation: Ensure the final shower surface has a flat area of 10 inches wide by 6 inches high for mounting the controller.
3. Valve Check: Confirm the shower valve is installed and pressure-tested before continuing with the controller installation.
4. Secure the Data Cable: Remove the data cable retainer to make sure the data cable stays in place within the wall.
5. Level the Mounting Bracket: Place the mounting bracket on the finished wall and ensure it's level.
6. Mark and Drill: Use a pencil to mark the drill holes on the bracket, then set the bracket aside. Drill through the finished wall using a 3/16" drill bit at the marked spots.
7. Apply Silicone: Add a bead of silicone caulking inside the groove of the mounting bracket.
8. Mount the Bracket: Attach the mounting bracket to the wall, making sure the data cable passes through the bracket opening. Secure it using the provided #6 x 2" mounting screws. Tighten with a Phillips screwdriver until the screw heads are flush or slightly recessed. Avoid over-tightening.
9. Re-Check Leveling: Ensure the mounting bracket remains level. Adjust if necessary, and clean off any excess silicone.
10. Connect the Controller: Remove the protective cap from the data cable. Attach the controller to the data cable.
11. Insert Cables: Push the cabling connection (data cable and controller) back into the wall through the mounting bracket.
12. Attach the Controller: Position the controller parallel and flush to the wall and press it onto the mounting bracket.
13. Lock into Place: Slide the controller downwards to lock it securely.
14. Final Check: Verify the controller is aligned correctly, parallel, and flush with the wall.

After completing the physical installation, proceed with setting up your Moen TS3302BL Digital Shower Controller and personalizing your shower preferences via the controller itself or the U by Moen app.

For thorough details, always refer to the complete Moen TS3302BL Digital Shower Controller Installation Guide, which includes extra steps and safety precautions.