Installing your KEEPSENS CCXG700 Wide Area Locator involves several steps, including mounting the host equipment and sensors. Here’s a detailed guide based on the provided manual:
-
Materials Needed:
- CS1000 equipment (host, no-load/heavy load sensor, and door opening/closing sensor).
- Host mounting bracket.
- Electric drill and 3.2mm/4.5mm drill bits.
- Chamfering bit (2cm diameter).
- M4 self-drilling tapping screws.
- Marking pen.
- M4 sunk Phillips screws (16mm length).
- M4 nuts, gaskets, and spring washers.
- Scouring pad or towel.
- White silicone sealant XD-6120.
- 1.8m herringbone ladder.
- Cross screwdriver and pincer pliers.
-
Host Installation:
- Insert the stud for the mounting bracket into the positioning hole on the host equipment.
- Position the host and mounting bracket in the groove on the left side of the container ventilation opening, ensuring correct distance and orientation.
- Use the marking pen to mark the mounting bracket hole positions on the container wall.
- Drill holes at the marked positions using the chamfering bit.
- Secure the mounting bracket to the container wall using screws, gaskets, spring washers, and nuts.
- Hang the host equipment onto the mounting bracket stud and secure it with gaskets, spring washers, and nuts.
-
Binding and Unbinding Equipment:
- Use the Tianjin Keepsens multi-machine configuration tool within the app to bind the host with sensors.
- Select the host and sensor equipment you want to bind and follow the app's on-screen instructions.
- To unbind, repeat the same steps and click the unbind button near the host equipment's Bluetooth number.
-
Important Notes:
- Make sure the host equipment is clean and dry before starting the installation.
- Use the tools and materials specified in the manual.
- Always follow all safety precautions and warnings. For any difficulties, contact the technical support of Tianjin Keepsens Information Technology Co., Ltd.
