Installing the ZEVNI A04551 Adkins 13 Inch 2 Light Vanity Light is straightforward when following these steps: First, gather your tools, including mounting screws, plastic wire connectors, and a screwdriver, as detailed in the ZEVNI manual. Safety is paramount; turn off the power at both the main fuse box and the wall switch before you begin. Next, assemble the light fixture. Unscrew the nuts from the back plate and set them aside. Attach tubes to the bottom of the sockets. Then, pass the supply wires through the mounting plate and secure it to the outlet box using the mounting screws. Proceed with the wire connections, carefully following the wiring diagram. Remember to connect the ground wire (bare copper wire) correctly. Twist the wires together with plastic wire connectors and secure each with electrical tape, ensuring no wire strands are exposed. After wiring, attach the back plate to the mounting plate by aligning the holes and using the nuts you set aside. Make sure it's snug against the wall. Now, secure the glass shades by unscrewing the socket rings, placing the shades on the sockets, and reattaching the rings. Finally, install the correct type of bulbs (not included) following the maximum wattage specified on the socket. Double-check all connections before restoring power. For safety, always adhere to the manual's recommendations, like consulting a licensed electrician if needed and using the correct voltage. If you have any problems, refer to the ZEVNI manual or contact their customer support.
