How do I synchronize my SCM Plus module with an external clock?

[OGriffin]

Synchronizing your SCM Plus module with an external clock source is straightforward. Here's how: First, connect your external clock source to the Clock In jack on the SCM Plus. The Clock In jack responds to a rising voltage edge of at least 2.5V. Second, if you're using another module to send a clock signal via the Clock Bus, ensure you've enabled clock reception through the Clock Bus by installing the Clock Bus jumper on the SCM Plus. This setup routes the Clock Bus signal directly to the Clock In jack. Finally, if you wish the SCM Plus to operate without an external clock, install the Free Run jumper. This will allow the SCM Plus to continue at the last tempo it received, even without an active external clock signal.