To ensure a secure and lasting installation of your Q-TRAN LALO Linear Fixture using the VHB adhesive method, proper surface preparation is key. Here's a detailed guide based on the manufacturer's recommendations:
-
Ideal Application Conditions: Aim for an environment between 70-100ºF with humidity at 50% or less. The minimum application temperature should be 50ºF. Maintain these conditions for 72 hours after application for optimal bond strength.
-
Cleaning Procedure: Thoroughly clean both the back of the LALO fixture and the surface where it will be mounted using a 50/50 alcohol mix. Allow the surface to dry completely for about 5 minutes.
-
Applying the VHB Adhesive: Begin by peeling back approximately 0.5 inches of the protective film from the VHB tape. Apply the tape to the surface, using firm pressure to eliminate air bubbles. Continue peeling the film and applying the tape in small sections until the entire length of the fixture is secured.
-
For Porous Surfaces: If installing on porous materials like wood, brick, or concrete, apply two coats of paint or primer to the surface before applying the VHB tape. This helps create a better bonding surface.
-
Recommended Epoxies for Various Materials: The following epoxy recommendations can further enhance the bond depending on the surface material:
- Concrete, Stone, Cinderblock, Metal, and Brick: Use Loctite Metal and Concrete Two-Part Epoxy.
- ABS, Fiberglass, Plastic, and PVC: Use Loctite Plastic Two-Part Epoxy.
- Tile, Wood, Ceramic, Glass, or Metal: Use Loctite Clear Two-Part Epoxy.
- All-Purpose: Use Strong Stik.
By carefully following these steps, you'll ensure a clean and well-prepared surface, leading to a strong and reliable installation of your Q-TRAN LALO Linear Fixture using the VHB adhesive method.
