Mounting the WAREHOUSE WMG Dimmable and CCT Tunable wall pack light fixture correctly ensures optimal performance and safety. Here's a step-by-step guide based on the provided instructions:
- Mounting Options: This wall pack can be mounted directly to a recessed junction box or directly onto the wall. Avoid upside-down or ceiling installations.
- Separate the Front Cover: Begin by separating the front cover from the rear housing to access the internal wiring. Disconnect the wires between the driver and the PCB board.
- Locate Mounting Points: On the back of the rear housing, you'll find pre-cast locators designed for lag-bolt surface mounting.
- Prepare the Housing: Use a hammer and punch to carefully knock out the appropriate mounting holes, as indicated in Figures 3 or 4 of the manual.
- Attach Conduit: Remove the necessary threaded plug from the housing to allow for conduit entry. Attach your conduit and then secure the fixture to the wall.
- Wiring Connections: Refer to the wiring diagrams in Figures 6.1, 6.2, 6.3, or 6.4 for correct wire connections. Ensure the ground wire from the front cover is connected to the ground wire in the rear frame.
- Seal Unused Entries: Any unused conduit entries must be plugged to prevent water or debris from entering the fixture.
- Final Verification: After installation, confirm that the fixture is firmly mounted and all wires are correctly connected. Turn on the power and verify the light is functioning. If you encounter any issues, turn off the power and consult your local dealer for assistance. Following these steps will help you properly install your WAREHOUSE WMG Dimmable and CCT Tunable wall pack light fixture.
