How do I configure the address for the ALCN-792M/ALCN-792MISO Quad Loop Adder Module using DIP switches?

[Billy]

Configuring the binary address for your ALCN-792M/ALCN-792MISO Quad Loop Adder Module is straightforward. Here's how to do it: First, locate the DIP switches, labeled SW1-1 through SW1-8, on the module. These switches control the address settings. Each switch represents a binary digit; 'ON' means active, and 'OFF' means inactive. Next, consult the DIP switch settings table in your module's manual. This table maps specific switch combinations to different addresses (typically, addresses 1 through 7). To set the address, configure the DIP switches according to the table. For instance, to set the address to '2', you might turn SW1-1 OFF, SW1-2 ON, and the rest OFF. After setting the switches, double-check your settings to make sure they match the address you want to assign. Finally, once the address is set, complete the installation and wiring, referring to the Network Fire Alarm Manual for guidance. By following these steps and using the manual's settings table, you can easily configure the binary address of your ALCN-792M/ALCN-792MISO Quad Loop Adder Module.