Method for performing a right-angle turn in Subject 2: 1. Adjust the position of the right rearview mirror, lowering it as much as possible to see the right rear tire when leaning to the side. 2. Slow down as much as possible when entering the right-angle turn, using the left wiper as a pivot point and keeping close to the left line of the turn. 3. After the front of the car passes the horizontal line before the right-angle turn, observe the inner line of the turn, turn the steering wheel fully to the right, and proceed slowly to complete the right-angle turn. The specific steps for a right-angle turn are as follows: 1. Park the vehicle at the starting position for the right-angle turn. After hearing the voice prompt, shift into first gear, release the handbrake, slowly lift the clutch, and maintain a semi-clutch state to start moving at a steady speed. 2. Drive the vehicle appropriately close to the left edge of the road, maintaining a distance of about 20-30 cm, which is generally the best range. Adjust this distance from the start and avoid making corrections when approaching the right-angle turn. 3. Once the distance is adjusted, focus on the right door window glass. When the A-pillar aligns with the horizontal line of the inner corner of the right-angle turn or when the front hood of the car just covers the yellow line ahead, turn the steering wheel fully to the right. 4. After completing the turn and feeling that the car is about to straighten, slowly return the steering wheel to the center, then turn it back to the left to keep the body parallel to the lane edge line. Turn off the turn signal and exit the test area.
