Installing the MAGVENT MV-90 Indoor Hook Up Dryer Vent Kit correctly is crucial for optimal performance and safety. Here's a straightforward guide to ensure a successful installation: Prerequisites of Install Make sure the dryer vent path has a 90-degree turn directly behind the dryer, whether it's up, down, left, or right. The drywall should already be in place. Tools Required Gather these tools: a tape measure, pencil, screwdriver or drill, tin snips, safety glasses, gloves, and an AC voltage sensor. Additional Requirements You'll need sufficient 4-inch rigid metal pipe, pipe strapping, and elbows based on your specific setup. Consider watching the video on estimating the right amount of rigid metal pipe for your dryer duct system. Safety Precautions Handle the powerful magnets with care. Avoid playing with them. Wear gloves to prevent pinching. Keep magnets away from electronic devices, magnetic storage media, and pacemakers. If you have any health concerns, consult a physician about handling strong magnets. Installation Overview Measure and mark the center of the dryer port on the wall. Mount the bracket and MV-90 to the wall and complete the duct path using rigid metal pipe. Attach the dryer-side union to the dryer exhaust port. Position the dryer, allowing the magnets to connect and complete the installation. Check the connection visually to confirm a proper seal. Step-by-Step Installation Step 1: Measure and mark the dryer port center on the wall. Step 2: Attach the bracket to the wall and mark hole locations. Step 3: Install wall anchors and screws for the bracket. Step 4: Secure the MV-90 to the bracket. Step 5: Measure for the remaining duct system components. Step 6: Connect the flexible duct securely to the dryer exhaust port. Step 7: Plug in the dryer and carefully push it into place, allowing the magnets to align and complete the duct connection. Following these steps will help you install your MAGVENT MV-90 Indoor Hook Up Dryer Vent Kit effectively and safely.
