Need help installing my Hunter 51289 52 Inch Tailwind ceiling fan with LED light?

[DaniellaAnn]

Absolutely! Here's a simplified guide to installing your Hunter 51289 52 Inch Tailwind ceiling fan with LED light. Remember to always consult the full Hunter instruction manual for detailed diagrams and safety information.

First and foremost: Safety First! Before you begin, cut off power at the circuit breaker for both the outlet box and the associated wall switch.

Step-by-step installation:

1. Location, Location, Location: Decide where you'll install your fan. For flat ceilings, use the standard downrod. Angled or vaulted ceilings require a longer downrod (sold separately) and, if the angle is over 34 degrees, an Angled Mounting Kit.
2. Mount the Ceiling Bracket: Secure the ceiling bracket to the ceiling fan-rated outlet box using the provided machine screws and washers. Alternatively, use wood screws and washers to attach it to a support structure with a suitable electrical outlet box.
3. Attach the Downrod: If using the pre-assembled downrod, remove the setscrew, carefully feed the wires to one side of the horizontal bar, and hand-tighten the downrod. Trim the wires and then tighten the setscrew firmly with pliers.
4. Hang the Fan: Carefully lift the fan and attach it to the ceiling bracket. Handle the fan housing or downrod to avoid damage during this step.
5. Wire the Fan: Connect the wires according to the wiring diagram in your Hunter 51289 manual using wire nuts. Make sure to ground the fan properly and comply with all local and national electrical codes.
6. Install the Canopy: Slide the canopy up to the ceiling bracket and secure it in place.
7. Attach the Blades: Fasten the blades to the blade iron posts.
8. Assemble the Light Kit: Connect the 9-pin plug from the motor housing to the plug connector in the light kit assembly. Align the keyhole slots and twist counterclockwise. Insert the saved assembly and tighten the screws. Install the switch housing plate using the short screws.
9. Install Bulbs and Glass: Follow the instructions in the manual for installing the light bulbs and glass.
10. Attach Pull Chains: Connect the pull chains to the fan housing.
11. Test the Fan: Once everything is connected, turn the power back on and test the fan to ensure it's working correctly.

Remember to refer to the Hunter 51289 52 Inch Tailwind with LED light Ceiling Fan Instruction Manual for all the specific diagrams and instructions.