
Starting your scheppach HP2500S Reversible Plate Compactor involves a few key steps. First, check the engine oil level by removing the dipstick, cleaning it, reinserting it (without screwing it in), and checking the level. Add the correct oil if necessary and reassemble the dipstick. Next, inspect the fuel level in the tank and add unleaded gasoline if needed, taking care not to overfill. Ensure the fuel valve lever is set to the ON position. For a cold engine, move the choke lever to the CLOSE position; otherwise, leave it OPEN if the engine is warm. Position the throttle lever about one-third of the way towards the FAST setting. Place the shift stick in the neutral position. Turn the engine switch to the ON position. Use the recoil starter, pulling the grip until resistance is felt, then pull briskly and return the grip gently. If the choke was closed, gradually move it to the OPEN position as the engine warms up. Finally, after warm-up, adjust the throttle to increase engine speed and set the shift stick to the desired position to start the plate's vibration and begin compacting. Always ensure the compactor is fully assembled and follow all safety guidelines in the instruction manual before operation.


