How do I shorten the forearm on my Fillauer 1910124 Motion Arm?

[Ursula]

Shortening the forearm of your Fillauer 1910124 Motion Arm requires careful execution to maintain its functionality. Here’s a step-by-step guide:

Tools you'll need:

• Forearm Cutting Tool
• Hacksaw blade
• Deburring tool or knife
• Fine sandpaper (220 grit)
• Two-part Urethane glue

Procedure:

1. Remove the wrist End Cap or Electric Wrist Rotator.
2. Insert the circular disc in the cutting fixture and secure the forearm section accurately using the provided parts.
3. Measure and mark the desired length on the cutting fixture.
4. Secure the cutting guide and arm in a vice and cut off the excess forearm.
5. Deburr the edges and sand the surface that will receive the end cap.
6. Attach the appropriate wires and test the connections.
7. Apply the two-part Urethane glue inside the forearm, insert the end cap, and twist a quarter turn to secure.
8. Allow the glue to set for one hour before applying stress.

Important Precautions:

• Do not remove the forearm cover.
• Ensure a waterproof terminal device is used.
• Avoid removing any unauthorized parts, screws, or covers.

For support in the Americas, Oceania, and Japan, contact Fillauer Motion Control at 801.326.3434 or [e-mail]. For support in Europe, Africa, and Asia, contact Fillauer Europe at [phone] or [e-mail].