
To safely jump-start your vehicle using the TYPE S AC532781 Jump Starter and Power Bank, follow these steps:
Preparation is Key: Before starting, ensure your vehicle is in Park (for automatic transmissions) or Neutral with the Emergency Brake engaged (for manual transmissions). Also, unplug any USB charging cables.
Locate Terminals: Identify the positive (+) and negative (-) terminals on your car battery. The positive terminal is usually marked with a plus sign and is often larger than the negative terminal.
Check Jump Starter Power: Turn on the TYPE S AC532781 Jump Starter by pressing the power button. Make sure the battery level is at least 50% or higher, as indicated on the LCD display.
Connect Jumper Cables: Insert the gray end of the jumper cables into the Jumper Cables Port on the Jump Starter. The LCD Display will show "Clamp cables to battery."
Connect the Red Clamp: Attach the red clamp to the positive (+) terminal of the car battery. This terminal might have a red plastic cover.
Connect the Black Clamp: Attach the black clamp to the negative (-) terminal of the car battery. This terminal might have a black plastic cover.
Ensure Secure Connection and Monitor the LED: Make sure the clamps are securely connected to the battery terminals. Check the LED status on the Polarity Circuit Protection Box. Proceed only if the LED is not flashing red and beeping. Consult the manual if there are issues.
Start Your Vehicle: Once the clamps are correctly attached, the LCD Display will read, "Ready, Start vehicle ignition." You have 45 seconds to start your car to prevent reverse charging.
Attempt to Start: Start your car's ignition. If the engine doesn't crank or cranks slowly, gently wiggle the cable clamps on the car battery to improve contact. Wait 60 seconds before attempting again.
Disconnect the Cables: After the engine starts, disconnect the cables within 30 seconds. Remove the red clamp first, then the black clamp. Unplug the gray end of the jumper cables from the Jump Starter to reset them.
Recharge Your Battery: Let your car engine run for 20 to 30 minutes, or drive the car to help recharge the vehicle battery.
Important Note: If the engine stalls shortly after jump-starting or when the jumper cables are removed, it might indicate a problem with your vehicle's charging system. Seek professional assistance from an auto mechanic for diagnosis and repair.
For additional safety information and precautions, always refer to the TYPE S AC532781 Jump Starter and Power Bank user manual.


