How do I customize the settings on my Good Earth Lighting SE1296-BP2-02LF1-G IP65 motion-activated security light to adjust detection range and light duration?

[VonIsabella]

Customizing the settings on your Good Earth Lighting SE1296-BP2-02LF1-G IP65 motion-activated security light is straightforward. Here's how to adjust the detection range and the duration the light stays on:

1. Initiate Customization: Start by using the TEST mode to customize the settings. Set the TIMER control to TEST to enable light activation even during daylight hours, which simplifies SetToGo adjustments.
2. Adjust Light Duration: Use the “Minutes” dial to determine how long the light remains on after motion is detected. Options include 1 minute, 2 minutes, 5 minutes, and 10 minutes.
3. Set the Detection Range: Use the “Range” dial to set the sensitivity of the PIR distance sensing. Options range from 10 feet (short range) to Max (up to 70 feet, extra long range).
4. Verify Range Settings: Perform a "walk-by test" to verify the range setting. Walk straight across the sensor field at the distance you set on the RANGE control. Adjust the sensor head if necessary, moving it up, down, left, or right to achieve the desired coverage.
5. Manual Override Mode: To switch to manual mode, turn the switch to the OFF position for 10 seconds and then back ON. This allows the light to turn on regardless of the time of day; however, the manual mode must be reset each day after the dusk-to-dawn feature cycles off.

Following these steps will allow you to tailor your Good Earth Lighting security light to your specific needs, optimizing both its performance and energy efficiency.