Installing the Jandy R0688600 Pro Series Variable Speed Pump correctly is crucial for its safe and efficient operation. Here's a simplified guide, referencing the manufacturer's instructions. Note: Always consult the official Jandy R0688600 Pro Series Variable Speed Pump manual for complete and up-to-date instructions. First, ensure all power to the pump is OFF at the circuit breaker. 1. Motor Drive Removal: Begin by removing the junction box cover screws and disconnecting high voltage, ground, low voltage communication, and any auxiliary load wires. Also disconnect the bonding wire from the bonding lug. Then, remove the four screws securing the pump motor drive and carefully lift it away from the motor body. Discard the old motor drive appropriately. 2. New Motor Drive Installation: Align the new motor drive with the pump motor body and secure it with the four screws. Wiring should be done by a certified electrician, following all National Electric Code (NEC) and local regulations. Bond the pump motor to all metallic pool components using a solid copper conductor. Properly ground the pump motor using the provided green wire and carefully insulate all connections to prevent shorts. Reinstall all conduit and junction box covers. 3. Controller Options: The Jandy R0688600 Pro Series pump can be controlled by various systems, including the JEP-R variable-speed controller, AquaLink RS, AquaLink PDA, or AquaLink Z4. Follow the specific instructions for connecting the pump to your chosen controller, always prioritizing safety. Remember to consult the full manual for the most comprehensive and up-to-date instructions. If you're unsure about any step, it's always best to consult a qualified pool professional.
