To set up the dual rate function for the aileron channels on your AMEWi T6REMOTE 6CH Remote Controller, follow these steps:
- Power Up: Start by ensuring your remote controller is switched on.
- Access Settings: Press and hold the MODE button for about one second. You'll hear a beep, and the display will initially show "REVERSE," with channel numbers blinking.
- Navigate to Dual Rate: Use the FLIP button to cycle through the options until the display shows "D/R" alongside channel numbers. This indicates the dual rate setting.
- Enter Adjustment Mode: Press the MODE button again to enter the dual rate adjustment mode. The first channel will begin to flash, signaling it's ready for adjustment.
- Select Channel and Adjust: Use the lever on the remote to select the specific aileron channel (usually channels 1, 2, or 4 based on your setup) you want to modify. The selected channel will flash. Then, use the up or down buttons to increase or decrease the control surface travel, effectively adjusting the sensitivity of the aileron response. You can tailor this to your flying style. A lower value provides less control surface movement (reducing sensitivity), while a higher value increases it (increasing sensitivity).
- Save Settings: Once you've set the desired dual rate value for the selected channel, press the MODE button to save the setting. The display will confirm the setting.
- Exit Settings: Press the END button twice to exit the entire setting mode and return to normal operation. Repeat the above steps for each aileron channel (e.g., left and right ailerons) to customize their individual dual rate settings.
This dual rate function is an excellent way to fine-tune the control sensitivity of your model helicopter with your AMEWi T6REMOTE 6CH Remote Controller, allowing for smoother and more precise control. For more in-depth instructions, refer to the AMEWi T6REMOTE 6CH Remote Controller Instruction Manual or reach out to AMEWI Trade GmbH customer support for assistance.
