How do I pair the transmitter and receiver on my Shanghai Ganite BSN-MMN industrial wireless remote controller?

[Joe]

Pairing the transmitter and receiver on your Shanghai Ganite BSN-MMN industrial wireless remote controller is essential for wireless equipment control. Here's a step-by-step guide:

1. Transmitter Activation:

   • Insert the battery into your transmitter.
   • Release the emergency stop button located on the side of the transmitter.
   • Find the "Start" button, usually in the upper right corner of the remote control panel, and press it to activate the transmitter.
   • Observe the transmitter's red "signal indicator," which should strobe once per second.

2. Establishing Communication:

   • Once the transmitter is active, it will try to connect with the receiver.
   • The receiver's "power/communication" indicator light will also strobe once per second when a connection is established.

3. Sending Control Signals:

   • Use the side buttons, the head switch (by shaking), or the rocker on the transmitter to send control signals.
   • The transmitter's "signal indicator light" will strobe three times per second when a control code signal is sent.
   • The receiver's "function" indicator light will also flash three times per second, confirming signal reception.

4. Emergency Stop Function:

   • In an emergency, press the "emergency stop" switch on the transmitter.
   • The receiver's "emergency stop/failure" indicator light will flash red and blue alternately to show signal action.

By following these steps, you can successfully pair your transmitter and receiver, enjoying wireless control of your equipment with your Shanghai Ganite BSN-MMN remote controller, typically within a range of at least 20 meters.