Balancing your binoculars on the BRESSER 4964180 SLIDER Mount is key for stable and enjoyable viewing. Here's how, based on the manual's guidance:
-
Mounting Your Binoculars:
- Make sure your binoculars have a tripod connection. If not, you'll need a tripod adapter with a 1/4" connection thread.
- Center your binoculars and the adapter(s) on the 1/4" mounting connection.
- Screw the mounting connection into the 1/4" thread of your binocular adapter from underneath to secure the binoculars to the mount.
-
Utilizing Counterweights:
- Attach the included counterweights to both sides of the locating pin.
- Slide the safety clamps onto the locating pin on both sides to keep the counterweights in place.
- Ensure the fuse clamps are correctly installed on the retaining bolts to prevent the counterweights from falling, which could cause injury.
-
Balancing with a Sandbag (Optional):
- Fill the sandbag with sand or stones and seal it tightly.
- Hook the sandbag's loop onto the hook on the pick-up bolt.
-
Adjusting Friction Screws:
- Use the friction screws on the mount to fine-tune movement in all directions (horizontal, elevation, zenith, tilting).
- Tighten or loosen the appropriate screws to adjust how freely the mount moves in each direction.
By following these steps, you'll achieve a balanced setup with your BRESSER 4964180 SLIDER Mount, ensuring steady and comfortable viewing experiences. Always consult the BRESSER manual for specific instructions and safety precautions.
