How can I program a transmitter with my TRIO2SYS EnOcean 16A DIN Rail Switch Receiver?

[Grant]

Programming your transmitter with the TRIO2SYS EnOcean 16A DIN Rail Switch Receiver is straightforward. Follow these steps:

1. Ensure the receiver is connected to the mains power supply.
2. Use a small insulated screwdriver to access the LRN or CLR buttons on the receiver.
3. To initiate programming mode, briefly press (about 0.5 seconds) the LRN button. The LED indicator will flash regularly, signaling that you've entered programming mode.
4. To associate a transmitter with the receiver, either activate one of the switches on the transmitter or press the LRN button on the receiver. The receiver will acknowledge the association by keeping the LED illuminated for 4 seconds. You can then proceed to associate another transmitter or clear an existing one.
5. To remove a transmitter, press one of the transmitter's switches or the LRN button associated with that specific sensor. The receiver will confirm the clearing process by turning the LED off for 4 seconds.
6. Alternatively, utilize the EnOcean UTE1 protocol for associating or deleting transmitters. After selecting the relay output, send a UTE Query1 type frame. The association or deletion is confirmed when the LED remains on or off for 4 seconds, and by sending a UTE Response1 type frame.
7. To exit programming mode, briefly press (about 0.5 seconds) the LRN button again. The LED's regular flashing will cease, indicating that you've successfully exited programming mode.

Additional points to consider:

• The receiver comes with no pre-programmed transmitters.
• If you're using BMS products, programming must be done individually, channel by channel.
• Each channel can accommodate up to 32 transmitters, switches, or sensors.
• If the memory is full, the receiver will automatically exit programming mode upon any additional association attempt.
• Transmitters are programmed or cleared alternately when multiple activations are made.
• The learn mode will automatically time out after 30 seconds if there's no button press.

By following these instructions, you should be able to successfully program your transmitter with your TRIO2SYS EnOcean 16A DIN Rail Switch Receiver.