···
Log in / Register

Where is the window regulator control box of Weizhi v5 located?

1Answers
McJayden
07/29/2025, 08:40:33 PM

Weizhi v5 window regulator control box is located behind the headlight switch. Controller: The controller consists of two parts, one part is the window lift control circuit, and the other part is the central locking control circuit. The two circuits are independent of each other and do not interfere with each other. Operation for removing the car window regulator switch: Turn off the ignition switch and all electrical appliances, and remove the ignition key from position 0 (pre-lock position). Use the pry bar set-NST1055– to unlock the locking lug-arrow- on the front side of the handle panel-1- and turn it out from the door trim in the direction of the arrow. Unlock and disconnect the plug connections-1- and -2-, and remove the handle panel. Unlock the locking lug-arrow- and remove the button module-1- from the handle panel.

Was this review help?
110
Share
More Q&A

At what mileage is the second maintenance for a car?

The second maintenance for a car is at 10,000 kilometers. The first maintenance should be done before 5,000 kilometers for a new car, and the second maintenance should be performed when it reaches 10,000 kilometers. A minor maintenance is required every 5,000 kilometers. Generally, a major maintenance is based on a minor maintenance, and these two types of maintenance are alternated. The time interval varies depending on the car brand and the wear and tear of the vehicle. Car maintenance, also known as car servicing, refers to the preventive work of regularly inspecting, cleaning, supplying, lubricating, adjusting, or replacing certain parts of the car. Car maintenance mainly includes the maintenance of the engine system, transmission system, and air conditioning system, aiming to keep the car clean and in normal technical condition, eliminate hidden dangers, prevent faults, and extend the service life.
119
Share

Who is at fault when the front car brakes suddenly and the rear car rear-ends it?

The rear car is at fault if it rear-ends the front car after the front car brakes suddenly. Below are specific explanations for different scenarios: 1. If the front car brakes suddenly and the rear car fails to maintain a safe distance, the rear car is at fault for the collision. 2. If the front car's brake lights are malfunctioning and not illuminated, causing the rear car to miss the braking signal and resulting in a rear-end collision, the front car bears secondary responsibility. 3. If the rear car stops but the front car rolls backward, leading to a rear-end collision, the front car is fully at fault. 4. If the front car violates traffic rules by changing lanes, crossing lines, or cutting in, and a rear-end collision occurs before the lane change is completed, the front car is fully at fault.
111
Share

What's the Situation When the Fuel Tank is Full but the Fuel Gauge Doesn't Show Full?

This is a common phenomenon encountered during refueling. Generally, it occurs when refueling too quickly while the fuel tank temperature is relatively high, causing gasoline vapor to suddenly rush out and "push" the fuel nozzle to trigger an automatic shut-off. If the fuel gauge needle consistently doesn't show full after each refueling, it's necessary to check the fuel tank float. Precautions for car refueling: 1. Do not wait until the warning light comes on to refuel. Since the fuel pump is located inside the fuel tank and relies on gasoline for cooling and lubrication, insufficient fuel volume will adversely affect the normal operation of the fuel pump and reduce its service life. 2. It is not recommended to fill the tank completely during refueling. Because gasoline expands when heated and evaporates into gasoline vapor under high summer temperatures, space is needed to accommodate this. If the tank is filled without any space, gasoline vapor or even liquid gasoline may enter the carbon canister for storage. When the carbon canister is full, it escapes into the air, which is not only wasteful but also pollutes the environment.
104
Share

What does the rear axle ratio mean for trucks?

Rear axle ratio mainly refers to large vehicles and heavy-duty vehicles, where there is a set of gears in the rear axle behind the driveshaft, primarily serving to reduce speed and increase torque. The rear axle ratio is the gear transmission ratio of the main reducer in the vehicle's drive axle, which equals the ratio of the rotational angular velocity of the driveshaft to that of the axle's half-shaft, and also equals the ratio of their rotational speeds. The rear axle ratio is an important parameter of the engine, commonly referred to as the rear axle ratio, with the academic term being the main reduction ratio. Here is more information about the rear axle ratio for trucks: 1. With the same engine and transmission, a larger rear axle ratio results in slower vehicle speed, higher fuel consumption, but greater power; a smaller rear axle ratio leads to faster vehicle speed, lower fuel consumption, but less power. 2. The rear axle ratio is related to gears. The power output from the engine and transmission acts on the driveshaft, which rotates to input power to the main reduction drive pinion, driving the main reduction driven gear to rotate, and then driving the half-shaft to rotate.
104
Share

What are the Pros and Cons of Car Floor Mats?

Car floor mats have the advantage of isolating dust and protecting the original car carpet, but the disadvantages are difficult installation and relatively high price. The benefits of car floor mats are as follows: Car floor mats are 1:1 matched with the original carpet, tightly fitted to the chassis cavity, with edges fully embedded and covered, integrating with the car's cavity without curling up, maximizing dust isolation and protecting the original car carpet; the compressed material of the fixed layer is thinner, saving more interior space. The double-layer combination enhances water absorption, dust absorption, stain removal, sound insulation, and moisture resistance, maximizing the protection of the main carpet and other interior parts from contamination and damage. The disadvantages of car floor mats are as follows: Installation is labor-intensive, for example, installing traditional floor mats is very labor-intensive and requires going to a car decoration shop for installation; the installation price is relatively high.
115
Share

What to Do When the Reversing Camera of BMW 5 Series Does Not Display?

The solutions for the reversing camera of BMW 5 Series not displaying: It might be due to poor harness contact. You can try restarting it. If it still does not display, it is recommended to check the following parts: 1. Check if the reversing camera is damaged. 2. Check the wiring of the reversing camera. The reversing camera is specifically designed for car reversing, making it convenient for the driver to observe the distance between the car and obstacles. Even at night, the reversing camera provides a very clear view. The dimensions of the BMW 5 Series are 4998mm in length, 1901mm in width, and 1559mm in height, with a wheelbase of 3070mm. The car features a large, one-piece kidney grille that enhances its imposing presence. The adaptive LED headlights with BMW Dynamic Beam technology replace the hexagonal design with a simple and slender horizontal L-shaped light strip, complemented by the new BMW Intelligent Laser Headlights with blue laser, exuding a vibrant aura.
112
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.