Where is the frame number of Jianghuai Junling located?

1 Answers
SanTucker
07/30/25 4:10am
The frame number of Jianghuai light-duty ordinary trucks is generally located in the middle of the right rear side of the frame and can be seen upon careful observation. The frame number is a set of seventeen letters and numbers, which is equivalent to the car's ID card. Relevant information about the frame number is as follows: 1. Introduction: The Vehicle Identification Number (VIN), or frame number, is a set of seventeen letters or numbers used on a vehicle to identify the manufacturer, engine, chassis number, and other performance data. 2. Related knowledge: To avoid confusion with the numbers 1, 0, and 9, the English letters "I", "O", and "Q" are not used. The 10th digit of the production year does not use "I", "O", "Q", "U", "Z", or "0".
Was this review help?
20
1
Share
More Forum Discussions

What are the symptoms of a damaged knock sensor?

The symptoms of a damaged knock sensor are: reduced engine power, knocking sounds from the engine, potential damage to the engine pistons and cylinder block, inability to detect engine knock signals, and failure to automatically retard ignition timing. The knock sensor is a component that detects engine knock. When the engine knocks, it vibrates, and the knock sensor receives pulse signals and relays them to the engine ECU. The ECU then reduces the ignition advance angle to prevent knocking. If the knock sensor is faulty, the engine warning light on the dashboard will illuminate. In such cases, it is essential to immediately visit a professional repair facility or a 4S shop for diagnostics. Use an OBD diagnostic tool to read the fault codes and then replace the knock sensor as needed.
16
5
Share

How to Check the Production Date of Car Glass?

To check the production date of car glass, look for the trademark in the corner of the glass, which consists of several dots and a number. The number represents the production year of the glass. If the dots are on the left, it indicates the first half of the year, while dots on the right indicate the second half. Car glass is manufactured by heating the glass to near its softening temperature in a furnace, then quickly transferring it to air grids with different cooling intensities for uneven cooling. This process creates varying stress levels between the main viewing area and the peripheral areas of the glass. Typically, glass produced using this technology is zone-tempered glass.
10
5
Share

What does the tire load index mean?

Tire load index, also known as tire load rating, is a numerical code indicating the maximum load capacity a tire can bear under specified usage conditions. The tire load index ranges from 70 to 109, representing maximum load capacities from 335 to 1030 kilograms. Exceeding the tire's maximum load capacity will not cause immediate damage, but prolonged overloading can lead to tire fatigue and shorten the tire's service life. It is recommended to inspect tires daily, primarily to check for any debris stuck in the tread, as these can affect the tire's lifespan. When parking for extended periods, avoid leaving the car outdoors to prevent sun exposure, as prolonged sunlight can damage the tires and cause aging.
18
1
Share

What Causes Uneven Wear on Front Tires?

The reasons for uneven wear on front tires are: 1. Tire quality issues; 2. Abnormal four-wheel alignment; 3. Improper tire pressure (too high or too low); 4. Uneven car suspension can also cause uneven wear; 5. Faulty steering gear can lead to uneven wear and pulling. Front tires are more prone to uneven wear than rear tires because the front wheel suspension alignment cannot be as stable as the rear wheels and is more susceptible to deformation. Due to steering requirements, the front wheels and suspension cannot have too many fixed points and are typically connected via a single pivot, such as in MacPherson strut suspension or through two ball joints. This type of tire, fixed along a single axis, has relatively poor resistance to deformation.
5
1
Share

Where is the production base of Haval H6?

Haval H6 has three production bases in Tianjin, Baoding, and Xushui, as well as under-construction bases in Yongchuan, Chongqing, and Rizhao, Shandong. Haval H6 is manufactured by Great Wall Motors Co., Ltd. and is a compact SUV with a 5-door, 5-seat body structure. The vehicle's dimensions are 4653mm in length, 1886mm in width, and 1730mm in height, with a wheelbase of 2738mm. The Haval H6 is equipped with a 2.0T 211-horsepower L4 turbocharged engine, paired with a 7-speed dual-clutch transmission, delivering a maximum power of 155 kW. The Haval H6 incorporates more fashionable, intelligent, and luxurious urban design elements, featuring a stylish and bold exterior, a warm interior, and intelligent equipment throughout the vehicle, meeting both the emotional and functional needs of urban SUV enthusiasts.
5
5
Share

What are the four driving modes of the Fista?

The four driving modes of the Fista are: ECO (Energy-saving), COMFORT, SPORT, and SMART mode. The Fista features a nearly inverted trapezoidal family-style "big mouth" grille on the front, with flat headlights on both sides and curved daytime running lights below. The Fista is a compact car equipped with a 1.6T 190-horsepower L4 turbocharged engine, paired with a 7-speed dual-clutch transmission, delivering a maximum power of 140 kW. Its body dimensions are 4660mm in length, 1790mm in width, and 1425mm in height, with a wheelbase of 2700mm.
14
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.