What to Do When the Car Door Freezes and Won't Close?

What is the ground clearance of the Santana?

The ground clearance of the Santana is 120mm. Ground clearance refers to the minimum distance between the ground and the chassis. A larger ground clearance enhances the vehicle's ability to pass over obstacles or uneven terrain, while a smaller ground clearance reduces this capability. The Santana is a compact car produced by SAIC Volkswagen, with dimensions of 4475mm in length, 1706mm in width, and 1469mm in height, and a wheelbase of 2603mm. The Santana is equipped with an engine coded as EA211-DLF, a 1.5-liter naturally aspirated engine. This engine delivers 112 horsepower and a maximum torque of 145 Nm, with a maximum power output at 6100 rpm and peak torque at 4000 rpm. The engine features multi-point fuel injection technology and utilizes an aluminum alloy cylinder head and block. The Santana uses a MacPherson independent suspension at the front and a compound torsion beam non-independent suspension at the rear.

114

Share

What are the differences between the Tucson and the ix35?

The differences between the Tucson and the ix35: 1. Different dimensions: The Tucson has a length, width, and height of 4670mm, 1865mm, and 1690mm respectively; the ix35 has a length, width, and height of 4500mm, 1850mm, and 1715mm respectively. 2. Different power: The Tucson has a maximum horsepower of 200ps and a maximum power of 147kw; the ix35 has a maximum horsepower of 140ps and a maximum power of 103kw. 3. Different wheelbase: The Tucson has a wheelbase of 2755mm; the ix35 has a wheelbase of 2640mm. Both the Tucson and ix35 use MacPherson independent suspension for the front suspension and a torsion beam non-independent suspension for the rear suspension.

118

Share

Why is the engine warning light on in the Nissan Qashqai?

There are mainly 7 reasons for the engine warning light to illuminate: Sensor malfunction: The sensors mentioned here include coolant temperature, crankshaft position, air flow, intake air temperature, oxygen sensors, etc. When these sensors are damaged, have poor contact, or signal interruption, the vehicle's ECU cannot accurately obtain engine data, which will trigger the engine warning light. Fuel/oil quality issues: If fuel or engine oil is not added according to the manufacturer's requirements, it may cause engine wear and trigger the warning light. Poor air-fuel mixture combustion: Poor combustion can lead to engine carbon buildup or knocking. When detected by oxygen sensors and reported to the ECU, the warning light will illuminate as a warning. Issues like spark plug failure, ignition coil failure, fuel pump failure, or fuel line blockage can all cause poor air-fuel mixture combustion. Turbocharging problems: Intake boost pipes or turbocharger issues can also trigger the engine warning light. The most common is turbocharger damage, often accompanied by symptoms like oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Intake problems: If there are issues with the vehicle's air intake, it may cause engine pipe blockages, potentially triggering the warning light. A dirty air filter that hasn't been cleaned regularly can lead to intake problems. Exhaust problems: Exhaust system faults can also trigger the engine warning light. Common causes include rear oxygen sensor failure, three-way catalytic converter issues, or exhaust camshaft and bearing failures. Using leaded gasoline, lead/silicon-containing lubricant additives, physical damage to the catalytic converter, or fuel system malfunctions can all cause three-way catalytic converter problems. Anti-theft system malfunction: If the electronic anti-theft system fails or the anti-theft controller doesn't match the engine ECU, the system may prevent normal engine operation while illuminating the warning light. When the engine warning light illuminates, follow these steps: First check if the engine is running normally. If there's shaking, black smoke, or other abnormalities, avoid restarting the engine. Note: Never restart if the red warning light is on. If the engine can start, turn it off for 5-10 minutes. Without pressing the brake pedal, press the start button once or turn the key halfway to the ON position (without depressing the clutch). The vehicle will enter self-test mode after powering on. Wait 5-10 seconds to see if the warning light turns off. If the light remains on, visit a service center immediately. Technicians can use diagnostic tools to read trouble codes, identify the issue, and perform targeted repairs.

108

Share

Why Does My BMW Make a Buzzing Noise When the AC is On?

BMW makes a buzzing noise when the AC is on for the following reasons: 1. Worn compressor bearings. 2. Dirty AC pipes or condenser: This can easily cause abnormal noise during gas transmission or lead to high-speed operation of the fan. 3. Defective suction pipe of the evaporator mechanical supercharger: Replace it with a suction pipe equipped with a muffler to increase the volume in the circuit and alter the sound waves. 4. The label of the blower falls off into the air duct. 5. Worn blower bearings. 6. If the buzzing noise occurs when accelerating at low speeds with the AC on, it is mostly due to issues with the engine belt or tensioner. After ruling out problems with AC-related components such as the compressor, evaporator, blower, etc., check if the belt has become loose.

105

Share

What is the engine oil specification for BYD Song?

BYD Song uses fully synthetic engine oil with the specification 5W-40. Turbocharged engines require at least 5W-30 oil, while some high-performance turbocharged engines can use 5W-40 oil. For later maintenance and oil changes, you can choose brands such as Mobil, Shell, Castrol, or Total. The viscosity of engine oil changes with temperature, so special attention should be paid to its performance under both low and high temperatures. For example, in 5W-30, the first number indicates low-temperature fluidity—5W means it can withstand temperatures as low as -30°C. The smaller this number, the better the low-temperature fluidity, making cold starts smoother. The latter number represents the kinematic viscosity of the oil at 100°C. A higher value means the oil can maintain viscosity better at high temperatures, which can also be understood as better lubrication performance under high-temperature conditions. The method for changing the engine oil in a BYD Song is as follows: Wait for the engine temperature to drop and allow the oil to flow back into the oil pan. Use a wrench to loosen the drain plug and place an oil pan underneath to catch the old oil until it stops flowing. Start the engine and let it run for 30 seconds to allow the oil in the main oil passage to drain out. Use a special wrench to remove the oil filter. Apply oil to the seal of the new oil filter and tighten it clockwise by hand. Add new oil through the engine valve cover filler port. Typically, fill about three-quarters of a standard oil container. Start the engine and let it run for 5 minutes, checking for leaks around the drain plug and oil filter. If leaks are found, perform necessary repairs. After stopping the engine, pull out the dipstick and check that the engine oil level is within the standard range.

109

Share

What engine does the Yipao use?

Yipao is equipped with a 1.4-liter naturally aspirated engine across the entire lineup. This is a small SUV under Kia, with the engine delivering a maximum power of 73.6 kW and a maximum torque of 132.4 Nm. The engine reaches its maximum power at 6,300 rpm and its maximum torque at 4,000 rpm. More details are as follows: 1. The engine features multi-point fuel injection technology and uses an aluminum alloy cylinder head and block. It is paired with either a 6-speed manual transmission or a 6-speed automatic transmission. 2. The front suspension of this vehicle uses a MacPherson independent suspension, while the rear suspension employs a torsion beam non-independent suspension. Additionally, its exterior design is very attractive. 3. The 2019 model of the Yipao complies with the China VI emission standards, making it a reliable purchase in regions where these standards have already been implemented.

109

Share