···
Log in / Register

What is the wading depth of the BYD Song Plus-DMi?

6Answers
VanOwen
08/27/2025, 04:32:34 AM

The wading depth of the BYD Song Plus-DMi is 150mm. The wading depth of the BYD Song Plus-DMi is determined by the height of the vehicle chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when passing through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a reference when passing through waterlogged roads. If the air intake of the BYD Song Plus-DMi is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before wading, always turn off the auto start-stop function to prevent the vehicle from automatically restarting after stalling in water, which could cause severe engine damage due to water ingestion. Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, use warning water level markers, trees, or the wheels and doors of other vehicles as reference points to judge the water depth before deciding whether to proceed. Know your vehicle's safe wading depth. If the water depth exceeds half the tire height or the engine's air intake, do not proceed and choose an alternative route instead.

Was this review help?
107
Share
VonValentina
09/09/2025, 03:12:15 AM

The official wading depth of the BYD Song PLUS DM-i is around 300mm, which means the water level should not exceed the midpoint of the tires. I usually pay attention to technical parameters, such as ground clearance and battery protection design, which are crucial. As a hybrid SUV, this vehicle has good battery waterproofing, but prolonged submersion increases the risk of short circuits. When wading, avoid driving too fast or braking abruptly, as water impact could damage the seals. My advice is to slow down and drive cautiously in heavy rain or standing water, and if the depth exceeds this limit, it's safest to take a detour.

Was this review help?
6
Share
Expand All
GeorgeMarie
10/23/2025, 04:02:35 AM

When driving the BYD Song PLUS DM-i, I'm quite cautious about wading through water. The manual mentions a depth of about 300mm, equivalent to the height of a standard basketball. From my own experience, I hesitate when the water exceeds 30 centimeters. Although the chassis is slightly higher, urban floodwater mixed with sediment can easily clog the exhaust system, affecting engine and battery cooling. While driving, try to pass through at a steady speed and avoid stopping in the middle of the water. Water that's too deep may cause electrical faults, so it's essential to regularly check the waterproof seals under the car and the condition of the tires.

Was this review help?
8
Share
Expand All
VanAlexander
12/06/2025, 03:25:50 AM

The BYD Song PLUS DM-i's wading capability is rated at 300mm, which is a standard value. I've seen similar SUVs like the Honda CR-V with comparable performance. Its tire's half-height waterproof design is practical, but in actual driving, turbulent water flow can create surges that may exceed the limit and damage the electronic control unit. After wading, I always remind myself to drive slowly and use the ventilation system to expel moisture, keeping the interior dry to prevent mold.

Was this review help?
17
Share
Expand All
AlainaMarie
01/26/2026, 09:53:07 PM

The 300mm wading depth is a reference line. From a safety perspective, I emphasize not to take risks. The hybrid structure of the Song PLUS DM-i increases the probability of battery short circuits in deep water. Even though the design waterproof test has an upper limit of 30cm water depth, in real road conditions, turbid water flushing can easily damage chassis components. It is recommended to avoid deep water areas and prioritize detours to prevent stalling and subsequent chain failures.

Was this review help?
13
Share
Expand All
VanReid
04/22/2026, 03:05:41 AM

The BYD Song PLUS DM-i has a recommended wading limit of 300mm. For daily driving, I calculate half the tire diameter as the standard. Exceeding this water depth may soak electronic modules, causing malfunctions. When wading, proceed slowly and steadily without accelerating to avoid splashing water into the engine or battery compartment. Afterward, inspect the chassis for residual water marks and clean promptly to maintain overall performance.

Was this review help?
17
Share
Expand All
More Q&A

What series does Mazda belong to?

Mazda belongs to the Japanese series. The models under Mazda include Mazda CX-5, Mazda CX-30, Mazda 3, Mazda 3 Axela, Mazda CX-8, and Mazda 2. Taking the Mazda CX-5 as an example: its length, width, and height are 4555mm, 1842mm, and 1685mm respectively, with a wheelbase of 2700mm, equipped with a 6-speed automatic manual transmission. The Mazda CX-5 is a 5-door, 5-seat SUV with a fuel tank capacity of 56L, and the engine's maximum power is 114 kilowatts, with a maximum power speed of 6000 revolutions per minute.
109
Share

What does the second session of Subject 1 mean?

Subject 1's first and second sessions actually refer to the exam time slots. Generally, the Subject 1 exam is divided into two sessions. The first session is usually before 10:00 AM, while the second session is between 10:30 AM and 12:00 PM. These are referred to as the first and second sessions. The Subject 1 exam offers two attempts. If you fail the first session, you can wait and enter the exam room again to take the second session. Below is an extended introduction: Exam Format: Typically, the Subject 1 exam consists of 100 multiple-choice and true/false questions. The Subject 1 question bank contains a total of 1,299 questions. During the exam, the computer-based driver system will randomly select and combine questions according to the regulations of the motor vehicle driver's license work specifications.
115
Share

What does it mean to start the engine?

Starting the engine means turning on the engine. Here is a detailed introduction to the engine: 1. Principle: The cylinder injects gasoline and air through the intake hole and fuel injection hole, which are fully mixed inside the cylinder. When the spark plug ignites the mixture, the mixture explodes and burns violently, pushing the piston downward and generating power. At the same time, the enormous pressure from the explosion also pushes open the exhaust hole of the one-way valve, expelling the exhaust gas. Subsequently, the residual exhaust gas in the cylinder gradually cools, the pressure decreases, and the external atmospheric pressure pushes the piston upward again, preparing for the next explosion. 2. Importance: The engine is the core part of the motor, so it is commonly referred to as the engine. The main component of the engine is the cylinder, which is also the power source of the entire car.
115
Share

How to Clear the Maintenance Reminder on the Dashboard?

Method to clear the maintenance reminder on the dashboard: Turn on the power, press the mileage reset button on the dashboard until the "flashing reminder" disappears, then start the engine and repeat the operation once. To ensure the normal operation of the vehicle, manufacturers have set up some reminder indicators during production. After reaching a certain mileage, the owner should promptly replace the relevant parts. Car maintenance mainly includes servicing the engine system, transmission system, air conditioning system, etc., aiming to keep the vehicle clean, maintain normal technical conditions, eliminate potential hazards, prevent faults, and extend the service life. Car maintenance, also known as vehicle servicing, refers to the regular preventive work of inspecting, cleaning, supplying, lubricating, adjusting, or replacing certain parts of the vehicle.
111
Share

What engine does the Fengxing CM7 use?

Fengxing CM7 is equipped with a 2.0-liter turbocharged engine across the entire lineup. This engine delivers a maximum power of 140kW and a peak torque of 250Nm, featuring multi-point electronic fuel injection technology, and utilizes an aluminum alloy cylinder head with a cast iron cylinder block. The Fengxing CM7 is a model under Dongfeng Fengxing, with body dimensions measuring 5150mm in length, 1920mm in width, and 1925mm in height, and a wheelbase of 3198mm. In terms of exterior design, the Fengxing CM7 adopts a family-style horizontal front grille, paired with rugged diamond-shaped headlight clusters on both sides. It features sliding side doors and a unique 'window within window' design, creating a more private business atmosphere.
103
Share

What Causes a Car's Brakes to Alternate Between Being Hard and Soft?

When a car's brakes alternate between being hard and soft, it is usually due to a damaged return spring. Replacing the return spring should resolve the issue. Below is relevant information about automotive brake fluid: Function: The role of brake fluid is to transmit hydraulic pressure when the brake pedal is pressed. The master cylinder increases the pressure of the brake fluid, causing the pistons in the wheel cylinders to extend under the action of the sealing rubber cups. This leverages the principle of mechanical advantage to apply force on the brake discs and pads, enabling the braking function. Replacement Interval: Most people believe that brake fluid replacement is solely based on time and mileage. However, it also depends on the climate and humidity of the region where the vehicle is used. In tropical regions, replace annually or every 20,000 kilometers; in cold regions, replace every two years or 40,000 kilometers; and in temperate regions, replace every three years or 60,000 kilometers.
116
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.