···
Log in / Register

What Causes the Engine to Fail to Start and Make Abnormal Noises?

6Answers
MacTaylor
08/28/2025, 12:10:05 AM

If there are abnormal noises but the engine fails to start, it could be due to issues with the spark plugs or insufficient fuel supply. Below is a detailed analysis of the specific reasons for abnormal engine noises: 1. Loose screws on the engine underguard: A relatively common minor issue that can be resolved by tightening or adjusting the screws. 2. Aging engine mount cushions: These cushions support the engine and need to be replaced once they age. 3. Loose plastic components in the engine compartment: Such as the engine cover or intake pipe, which can be fixed by tightening. 4. Abnormal noises from the engine belt: Including the power steering belt and alternator belt. Worn, overly loose, or overly tight belts can cause abnormal noises and should be replaced or adjusted for proper tension. 5. Engine knocking: Caused by excessive carbon buildup inside the engine or the use of substandard fuel. Clean the carbon deposits and replace the fuel.

Was this review help?
101
Share
GiaDella
09/09/2025, 10:42:22 PM

When it comes to the engine failing to start accompanied by strange noises, I'd like to share my experience. The most common issue is a weak battery – when the charge is too low, the starter motor can't turn properly, producing a clicking sound like the battery is struggling. If the noise is more metallic and screeching, it could indicate worn bearings or carbon brushes in the starter motor, or misaligned starter gears. Another possibility is a faulty fuel pump; insufficient fuel supply leads to difficult starts with a humming sound. I strongly advise against repeatedly turning the key as this may damage additional components and increase repair costs. Regular battery life checks and starter system maintenance can prevent these issues. If this happens, seek professional help immediately rather than forcing it. Always prioritize vehicle maintenance, especially during extreme winter or summer temperatures when problems are more likely to occur – safety first is never wrong.

Was this review help?
9
Share
Expand All
Hector
10/23/2025, 11:32:39 PM

Hey bro, I've encountered this issue quite a few times. If the car won't start and makes strange noises, nine times out of ten it's either a dead battery or a faulty starter - you'll hear a grinding or clicking sound during startup. Loose battery terminals can also cause this, so first check if the connections aren't tightened properly - a simple tightening might solve it. If the noise is a high-pitched squealing, it could be a loose belt or a stuck alternator causing weak startup. Don't keep trying to start it continuously, as you might burn out the electrical circuits - the gain wouldn't be worth the loss. Quickly use a multimeter to check the battery voltage, and replace it if it's low. Remember to turn off lights and electronics when parking to extend battery life. If you really can't figure it out, go to a repair shop - it's not worth letting a small problem turn into a big one.

Was this review help?
4
Share
Expand All
OCaroline
12/06/2025, 10:56:19 PM

I think the engine won't start and there's a strange noise, mostly due to electrical system failure. The battery is depleted with insufficient power, the motor can't turn and makes noise; or the starter motor is damaged producing abnormal sounds. Check the tightness of the battery terminals. Stop attempting immediately to avoid damage. Have a technician use tools to diagnose and fix it quickly. Regular maintenance can prevent this.

Was this review help?
3
Share
Expand All
LeLondon
01/27/2026, 12:09:44 AM

Engine failing to start with abnormal noises is quite common. It could be due to an aging battery with insufficient voltage, causing a buzzing sound during startup but the car doesn't move. Or, if components inside the starter motor like carbon brushes are worn, there will be a harsh grinding noise. Additionally, if the ignition system components such as spark plugs get damp, starting will be jerky with slight clicking sounds. Avoid forcing ignition to prevent circuit overheating or part burnout. Normal battery voltage should be above 12 volts; replace it if lower. Regular maintenance like checking starting components reduces risks. These issues are more prone to happen in winter, so preventive maintenance saves trouble.

Was this review help?
12
Share
Expand All
MacCayden
04/22/2026, 10:21:43 PM

Friend, this issue requires serious attention. An engine failing to start accompanied by abnormal noises is a warning signal—the sounds indicate the source: clicking noises typically point to battery or starter motor failure, while grinding sounds may involve mechanical components like belts or internal engine problems. Forcing a start will only exacerbate the situation, potentially causing irreversible damage to the engine. It's advisable to cease all attempts immediately and contact professional repair or towing services. Regular quarterly inspections of the battery and starting system can prevent such issues—for example, checking the voltage every six months. Don't wait until the problem escalates to take action; addressing it early saves time, money, and peace of mind.

Was this review help?
9
Share
Expand All
More Q&A

Why Doesn't the Emgrand GL Hold Its Value Well?

Here are the reasons why the Emgrand GL doesn't hold its value well: 1. Slightly High Fuel Consumption for a New Car: Due to its weight and powertrain, the new car's combined fuel consumption per 100 kilometers is relatively high. If frequently driven in urban areas, owners need to consider whether the fuel consumption is within their acceptable range. The old Emgrand's power and fuel consumption were quite attractive at the time, which was a significant advantage. However, this car continues to use the old Emgrand's engine while increasing the vehicle weight. As a result, the performance in terms of power and fuel consumption is not impressive, and for a next-generation model, it's quite disappointing. 2. Dual-Clutch Transmission Instability at Low Speeds: The dual-clutch transmission may be off-putting to some. The Emgrand GL's dual-clutch is among the smoother ones on the market, close to an automatic transmission. However, this doesn't mean its quality has improved. In fact, many people question the use of a dual-clutch in this model. If traffic isn't extremely congested but just slow-moving, frequent acceleration and deceleration are required, causing the transmission to frequently shift between 1st and 2nd gears, leading to jerking and surging. 3. Limited Interior Storage Space: One drawback of the Emgrand GL is the practicality of its front-row storage spaces. The main issue is the lack of suitable places for phones and wallets. There are storage slots on both sides of the center console, but they are blocked by the thighs, making it inconvenient to retrieve items while driving. The cup holders have good depth and diameter, but the small storage slot is barely useful—just the right size for keys. However, since the car comes standard with keyless entry and start, drivers don’t need to take out their keys, making the slot redundant. It would be better if the slot were larger or designed as a card slot. 4. Poor High-Speed Power Performance: The Emgrand GL's small-displacement turbocharged engine excels in mid-range acceleration, such as from 40 to 80 km/h, making it suitable for urban driving. However, acceleration at higher speeds weakens due to the small engine size and limited power reserves. During highway driving, some complaints arise. Even when downshifting early and pressing the accelerator hard, the car struggles to deliver a satisfying acceleration experience, with the speedometer needle rising rather slowly.
110
Share

How Many Years Are Vehicles Exempt from Inspection?

According to the new annual inspection regulations implemented on November 20, 2020, new 7-seat vehicles within 6 years are required to undergo an inspection every two years, without the need for an on-site inspection. Under this new policy, the scope of exempted vehicle inspections has been expanded. In addition to the existing exemption for non-commercial small and mini passenger vehicles with 6 seats or fewer within 6 years, non-commercial small and mini passenger vehicles with 7 to 9 seats (excluding vans) within 6 years are now also included in the exemption. For non-commercial small and mini passenger vehicles (excluding vans) older than 6 years but less than 10 years, the inspection frequency has been adjusted from once a year to once every two years. However, if the vehicle is involved in a fatal accident or is illegally modified and penalized, it will still be inspected according to the original cycle. After the implementation of the new measures by the Public Security Bureau, the application requirements for medium and large truck and bus driver's licenses have been optimized. The minimum age for applying for a large bus or tractor license has been lowered from 26 and 24 years old to 22 years old, respectively, while the maximum age for applying for medium and large truck and bus licenses has been raised from 50 to 60 years old. Additionally, the interval for license upgrades has been shortened. For applicants with no record of full demerit points in the corresponding scoring cycle, the required time to apply for a large bus license after obtaining a large truck license has been reduced from at least 5 years to 3 years, and the time to apply for a tractor or medium bus license after obtaining a large truck license has been shortened from at least 3 years to 2 years.
118
Share

Should the Brake Be Applied When Reversing into a Parking Space?

Reversing into a parking space can involve applying the brake, but stopping midway is not allowed as some computer systems may misinterpret it as a halt. Therefore, it's best to avoid using the brake and instead control the speed with the clutch. Below are detailed explanations regarding brake usage when reversing into a parking space: Sequence of Clutch and Brake: In these two test items, the clutch should be fully depressed first, followed by quickly pressing the brake. Since the entire process in Subject 2 is conducted in first gear at a low speed, the vehicle won't shake. Depressing the clutch is necessary because the low speed in Subject 2 exams means that not using the clutch when reversing into a parking space could stall the engine, leading to test failure. Reversing into a parking space in Subject 2 requires stopping to shift into reverse gear, so applying the brake to stop won't result in point deductions. Moreover, one key aspect of reversing into a parking space is controlling the speed, which can be managed by using the clutch or brake. A slower speed provides sufficient reaction time and room for correction. When aligning the car body to reverse into the parking space, observe the alignment of the lower edge of the left rearview mirror with the parking space line, and then apply both the brake and clutch to stop. Introduction and Function of the Brake: The brake, also known as the decelerator, refers to the action of stopping or reducing the speed of moving locomotives, vehicles, other transportation tools, or machinery. The braking system is a mechanical device designed to slow down the speed, also referred to as a decelerator. The braking system consists of a control system, hydraulic system, and power assist system. The control system includes the pedal, handbrake, etc. The hydraulic system comprises hydraulic fluid, brake pumps, and hydraulic lines. The power assist system includes the vacuum booster. It ensures driving safety and maximizes the vehicle's power performance. At any speed, it can forcibly decelerate or stop the vehicle.
105
Share

How to Activate One-Touch Window Control for Honda Haoying?

First, open the window by pressing the button to the first position (pressing too hard will reach the second position), and release the button once the window reaches the desired position. Next, press the button firmly to reach the second position, and the window will fully open. Then, close the window by pulling the button to the first position (pulling too hard will reach the second position), and release the button once the window reaches the desired position. Finally, briefly pull the switch to the second position to automatically close the window.
109
Share

How to Remove the Transmission?

Remove the screws of the drive shaft and lower the drive shaft. Unscrew the transmission oil drain plug, drain the gear oil into a container, and tighten the drain plug after the oil is completely drained. Next, disconnect the reverse light wiring and remove the transmission cover plate inside the cabin. Then, unscrew the ground wire fixing screw and remove the ground wire. After that, release the clutch release fork. Remove the connecting screws between the transmission and the flywheel housing. Finally, unscrew the transmission support plate fixing screws and lift the transmission off the vehicle.
104
Share

How to Check the Status of a Driver's License in the System?

First, open the Traffic Management 12123 app and register by entering your ID card number, real name, mobile phone number, and other information. Click 'Agree to the Agreement and Continue'. Complete facial recognition. Upon successful facial recognition, registration is complete, and the system will directly enter the login interface. Enter your ID card number and login password. At the driver's license information section at the top of the screen, the accumulated points and clearance date are displayed directly. Click to enter. Finally, the system will display the information of the registered driver's license, including the driver's license number, document status, and other details.
106
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.