···
Log in / Register

Is XPeng a Domestic or Joint Venture Brand?

1Answers
DelMaverick
07/29/2025, 01:31:50 PM

XPeng is a domestic brand, an independent company specializing in the production of pure electric vehicles. XPeng's vehicle lineup includes models such as the XPeng P7 and XPeng G3. The XPeng P7 is a mid-size pure electric sedan with a wheelbase of 2998 mm, and dimensions of 4880 mm in length, 1896 mm in width, and 1450 mm in height. The P7 is available in rear-wheel drive and all-wheel drive configurations, with the all-wheel drive version featuring dual motors and the rear-wheel drive version equipped with a single motor. All XPeng P7 models use ternary lithium batteries, which offer higher energy density and lighter weight. Most pure electric vehicles and plug-in hybrid vehicles utilize ternary lithium batteries. The front suspension of the XPeng P7 employs a double-wishbone independent suspension, while the rear suspension uses a multi-link independent suspension.

Was this review help?
117
Share
More Q&A

What Causes the Car Maintenance Warning Light to Illuminate?

When the car maintenance warning light comes on, it indicates that there is an issue with the vehicle, alerting the owner to perform necessary repairs or maintenance. If the dashboard warning light illuminates, the driver should stop the car to inspect for any problems and promptly identify the issue or proceed directly to a repair shop for servicing to avoid potential accidents while driving, which could damage the vehicle. Details about common warning lights: 1. Oil Pressure Warning Light: Indicates that the oil level or pressure is below the standard value. Continuing to drive may cause the engine to lose lubrication, leading to severe wear. 2. Coolant Temperature Warning Light: Displays the temperature of the coolant inside the engine. 3. Engine Warning Light: Shows the working status of the engine, typically in yellow. When turning the key for the self-check, if this light remains on, it suggests there may be a fault in the engine system.
118
Share

Why does the car only stop when the brake is fully pressed?

The reasons why the car only stops when the brake is fully pressed are: 1. Excessive gap between the brake pads and brake drum; 2. Air in the brake master cylinder; 3. Worn brake pads, deteriorated brake fluid, or leaking brake fluid lines; 4. Sticking brake caliper not returning, worn master cylinder seals causing air leaks, or malfunctioning ABS pump. Braking techniques include: 1. Releasing the brake slightly before the car comes to a complete stop, as holding the brake continuously can cause a strong impact when the car stops. The technique is to release the brake once before the car fully stops, then gently press the brake again until the car comes to a halt; 2. When braking during a turn, pressing the brake while steering can cause the car to lose balance. It is advisable to reduce speed adequately by braking before entering the turn.
115
Share

Which unit does the military license plate HN belong to?

Military license plate HN belongs to the General Armament Department. Military vehicle license plates are the identification marks for military vehicles of the Chinese People's Liberation Army (including the Armed Police Force). They are registered license plates with unique codes issued by the military transportation department after reviewing, inspecting, and registering the vehicles applying for the plates. These plates serve as proof of the special operating rights granted to military vehicles by the state. License plates are metal or plastic plates attached to the front and rear of a vehicle, typically made of aluminum, sheet iron, plastic, or paper, displaying the vehicle's registration number, registration region, or other relevant information. License plates serve as the numbering and information registration system for vehicles, primarily enabling identification of the vehicle's registered region and facilitating access to the owner's details and registration information through the plate number.
104
Share

Will driving schools cancel training sessions when it rains?

Driving schools will not cancel training sessions when it rains, primarily because driving tests may also occur during rainy conditions. When training in the rain, pay attention to the following: 1. Choose shoes with patterned soles: Shake off any water on the soles before getting into the car, and after entering, rub the soles against the car floor a few times before placing them on the clutch or brake to prevent slipping; dry your hands before placing them on the steering wheel to avoid slipping. 2. Learn to use the windshield wipers: The wiper control is located on the lower right side of the steering wheel, directly opposite the turn signal button. 3. During rainy tests, try not to close the windows: Rain already reduces visibility, so keeping the windows open allows for better viewing of the rearview mirrors and reference points.
101
Share

What to Do When the Car Battery Dies and Cannot Start the Engine?

When the car battery dies and cannot start the engine, there are mainly four solutions. Below is a detailed introduction to these four methods: 1. Jump-start with jumper cables: The prerequisite for jump-starting is the presence of another functioning vehicle with the necessary tools. Simply open the hoods of both vehicles and connect the positive and negative terminals of their batteries. 2. Push-start: Push-start is suitable when there is enough manpower and the vehicle is a manual transmission. Push-starting is relatively difficult and tests the driver's operational skills. 3. Emergency power supply: If the vehicle is equipped with an emergency power supply, a dead battery can be easily resolved by connecting the emergency power supply to the battery. The emergency power supply can provide temporary power to the car. 4. Call for roadside assistance: Generally, insurance companies offer this service, which is highly efficient.
116
Share

How to Activate One-Touch Window Lift for Odyssey?

To activate the one-touch window lift function for the Odyssey, follow these steps: 1. Locate the window control switch on the driver's side door panel, press and hold the switch until the window is fully closed, then continue holding for approximately 5 seconds; 2. Lower the window completely and press and hold the switch again for more than 5 seconds. Taking the Odyssey 2021 Comfort Edition as an example, its body dimensions are 4847mm in length, 1820mm in width, and 1702mm in height, with a wheelbase of 2900mm. It is equipped with a 2.0L naturally aspirated engine, paired with an electronic continuously variable transmission, featuring front-wheel drive. The front suspension is a MacPherson independent suspension, while the rear suspension is a torsion beam non-independent suspension.
104
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.