How to reset the maintenance light on Chery 3x?

[StMaverick]

Turn off the ignition switch, at this time the instrument panel is in a power-off state; Locate the "Maintenance Reset" button on the instrument panel and hold it down without releasing; Turn the ignition switch to the "ON" position; Wait for a few seconds until the small wrench symbol on the instrument panel disappears, indicating that the maintenance light has been successfully reset.

[MiguelDella]

Manually resetting the maintenance reminder light on the Chery Tiggo 3x isn't difficult - I've helped friends do it three times. The key is locating that small black protruding button on the instrument cluster (usually on the right side of the speedometer). With the engine off, press and hold it, then turn the key to power up the instrument panel while maintaining pressure for about 8-15 seconds. Release when you see the maintenance light start flashing, indicating the system is resetting. Important notes: keep the steering wheel straight and don't press the brake during power-up. Procedures vary slightly by model year - 2017 versions require slightly shorter holds while 2020 models need longer. Some instrument clusters may display a countdown; wait until "00" disappears to confirm success.

[LaKathryn]

To reset the maintenance reminder light, remember this mantra: 'Turn off, press, power on, wait.' No need to start the engine during the operation; the key is to let the vehicle's computer re-recognize the status. Firmly press the small black button (approximately 3mm in diameter) after powering on, and the maintenance reminder light will first illuminate, then flash three times before turning off. Some models require performing the operation twice consecutively to succeed, such as pressing for 5 seconds and releasing, then repeating the complete process. If the wrench icon on the dashboard turns yellow, it indicates that maintenance is needed soon rather than just a reset. Before starting the engine, observe the changes in the dashboard lights; all warning lights will illuminate for a self-check when powered on but not started, with the maintenance light being the icon featuring a wrench symbol.