How often should the spark plugs of a Teana be replaced?

1 Answers
StGabriella
07/29/25 7:39am
The spark plugs of a Teana are recommended to be replaced after driving more than 40,000 kilometers or approximately every three years. Under normal maintenance conditions, car spark plugs should be replaced after driving 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine, so it is advisable to follow the user manual. The following standards can be referenced for maintenance replacement: platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs at 60,000 to 80,000 kilometers. Steps for replacing spark plugs: Open the engine hood, lift the plastic cover of the engine, and remove the high-voltage distributor wires. Mark the position of each cylinder to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. When removing them, check for external debris such as leaves or dust and ensure they are cleaned thoroughly. Place the new spark plug into the spark plug hole, hand-tighten it a few turns, and then use the socket to tighten it further. Install the removed high-voltage distributor wires in the firing order and secure the cover.
Was this review help?
20
0
Share
More Forum Discussions

How to Turn Off the Auto Start-Stop in a Car?

Depress the brake pedal while the vehicle is in normal operation. The auto start-stop system will activate, and the indicator light on the dashboard will illuminate. Press the OFF button for the auto start-stop system.
10
4
Share

How to Place a Motorcycle Temporary License Plate?

However, it should be affixed to one side of the motorcycle body in a position that does not obstruct the rider's view, ensuring the safety of motorcycle riding. It is a document issued by the vehicle management authority that permits temporary cross-regional driving. With the temporary license plate, the vehicle is allowed to drive temporarily within the specified time and roads.
12
5
Share

How to Activate the Rearview Camera on a BMW?

Navigate to the factory settings menu in the general settings and click. After entering the setup password, click OK, then set the radar display menu to ON. Vibrant guide lines will appear in the rearview camera.
14
5
Share

How to Use the Pedals When Maintaining Low Speed After Wading?

During emergency braking, you should hold the steering wheel with both hands and avoid operating it with one hand. The free travel of the brake pedal directly affects the braking time and distance. Therefore, it is essential to check whether the free travel of the brake pedal is appropriate before driving.
10
3
Share

How to Walk Around the Car in the Driving Test (Subject 3)?

Unfasten the seat belt. Open the car door, get out of the car, and close the door properly. Walk around the car clockwise or counterclockwise for one full circle. Open the car door, get back into the car, fasten the seat belt, and continue with the test.
13
3
Share

What to Do When the Engine Fault Light Comes On After Wading Through Water?

Check the water temperature gauge and the oil pressure warning light. If the water temperature gauge and the oil pressure warning light are not alarming, the car can still be driven, but be sure to control the speed. If you clearly feel that the vehicle has a malfunction, you should immediately pull over and call the repair station for assistance.
8
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.