Can I take Subject Four if I passed Subject Three but failed Subject Two?

Where is the rearview mirror heating switch for the 2020 RAV4 Feng Shang?

The rearview mirror heating switch button for the 2020 RAV4 Feng Shang is located on the air conditioning control panel and shares the same button as the rear window defroster. The button features a rectangle with three upward-curving arrows at the bottom. Rearview mirror heating is particularly useful during rainy or snowy weather. When activated, the heater behind the mirror quickly warms the surface, gradually removing rain or fog without the need for frequent manual wiping, thereby reducing driving hazards. Principle of the rearview mirror heating function: After pressing the button, the electric heater behind the rearview mirror glass rapidly heats up to a fixed temperature within minutes, typically between 35-60 degrees Celsius. The heat is distributed across the left and right rearview mirrors. Simultaneously, as the temperature rises and evaporation occurs, water droplets on the mirror surface shrink, and fog gradually dissipates, effectively clearing frost and condensation. However, in heavy rain, the effect may diminish and become less noticeable. Precautions for using the rearview mirror heating function: The rearview mirror heating function works by incorporating electric heating wires, which consume a significant amount of power. Ensure the vehicle is running when using this feature to avoid draining the car battery, which could prevent the engine from starting. Avoid activating the rearview mirror heating while the car is stationary. Additional methods for defogging rearview mirrors include: Opening windows slightly to allow air circulation between the inside and outside of the car, reducing the temperature difference and gradually eliminating fog. Adjusting the car's air conditioning to the appropriate setting to blow warm air for defogging.

107

Share

How to Change the Local Registration of a Driver's License?

The change of driver's license registration is explained as follows according to relevant regulations: 1. If the household registration of a motor vehicle driver is moved out of the jurisdiction of the original vehicle management office, they should apply for a license change at the vehicle management office of the new location. 2. If a motor vehicle driver resides outside the jurisdiction of the vehicle management office that issued the license, they can apply for a license change at the vehicle management office of their residence. 3. When applying, the "Motor Vehicle Driver's License Application Form" should be filled out, and the driver's identity proof and motor vehicle driver's license should be submitted. Additional information: 1. Local residents transferring an out-of-town driver's license: (1) Present the original ID card and its copy, along with two recent one-inch color photos without hats. (2) Fill out the "Motor Vehicle Driver's License Application Form". (3) Submit the original driver's license and its file for approval by the business supervisor, who will unseal and review the file to ensure it is complete, authentic, and valid. (4) After online verification and passing the road driving retest (Subject 3), the transfer procedure will be completed. (5) Retain the "Motor Vehicle Driver's License Application Form", "Motor Vehicle Driver's License Registration Item Form", and "Motor Vehicle Driver's Transfer Notice" from the original driver's license file. 2. Non-locals transferring an out-of-town driver's license: (1) Present the original ID card and its copy, household relocation proof, labor and personnel department transfer order, and two recent one-inch color photos without hats. (2) Other procedures are the same as for local residents transferring an out-of-town driver's license.

110

Share

What lights should be used when driving at night?

When driving at night, you generally turn on the width indicator lights and low beams. If the lighting is insufficient or there are few oncoming vehicles, you can also use high beams. However, it's important to note that when encountering oncoming traffic, you should switch from high beams to low beams to prevent affecting the visibility of the oncoming vehicles and causing safety hazards. Here is some additional information: 1. Night driving: Strictly controlling your speed is the fundamental measure to ensure safety. Maintain a moderate speed, increase your following distance, and be prepared to stop at any time. To avoid potential dangers, try to increase your following distance to prevent collisions with vehicles in front or behind. 2. Driving in the city: Pay attention to pedestrians crossing the road from the left. Especially since streetlights in urban areas are mostly on both sides of the road, the area near the centerline is often poorly lit, so extra caution is needed in such situations.

119

Share

Why does the ABS light come on?

ABS light comes on due to weakened signals or loose wiring. The solution is to clean the sensors thoroughly and reinstall the wiring. When the sensing part of the ABS speed sensor is covered by dirt, mud, or other contaminants, it affects the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from identifying the vehicle speed and determining the wheel slip rate, thus failing to issue appropriate commands to adjust braking. Solution: Clean the dirt from the speed sensor and adjust the gap between the speed sensor and the signal ring to restore normal operation. System malfunctions can also occur due to poor signal quality caused by loose connections between system lines or poor contact in ABS relays. The most common issue is a loose speed sensor wire connection, which will also show as a poor speed sensor signal in the ABS computer's fault memory. Solution: Check all wiring connections, reconnect any loose parts, and verify if the fault is resolved.

113

Share

Will a hot charging battery explode?

Battery heating during charging will not cause an explosion. It is normal for a car battery to heat up during charging. When the battery is charging, the electrolyte inside will be in a boiling state, so when you touch it with your bare hands, you will naturally feel the battery heating up, and theoretically, there is no risk of explosion. Below are some relevant details: 1. Abnormal heating: If the heating is abnormal, it may lead to thermal runaway of the battery, causing it to swell. This abnormal phenomenon occurs because the car battery has become severely sulfated and requires timely repair. 2. Repair method: The method to repair a sulfated battery is to discharge the battery, then pour out the original electrolyte, and charge it with a low current within a temperature range of 20 to 40 degrees Celsius. After the charging is completed, the sulfation phenomenon will be eliminated, and the battery capacity can basically be restored to more than 80%.

104

Share

Can I Transfer Between Driving Schools?

It is possible to transfer to another driving school during the course of learning to drive. As early as 2019, the small vehicle driver's license test was implemented nationwide, allowing individuals to apply for a driver's license in any city across the country with just their ID card. If you need to change your place of residence due to work, study, or other reasons during the learning process, you can transfer to another driving school. The process for transferring driving schools mid-course is as follows: 1. Apply to the driving school: After the driving school agrees, use your ID card to complete the transfer procedures and obtain a transfer certificate; 2. Retrieve your records: Go to the vehicle management office or the driving school to retrieve your electronic records; 3. Enroll: After selecting a new driving school, bring your ID card, electronic records, and transfer certificate to register; 4. Transfer registration: After registration, use your ID card and electronic records to complete the electronic transfer registration at the local vehicle management office; 5. Learning: Once the transfer is successful, you can begin learning and taking tests.

102

Share