Need help installing the INTERMATIC ET2725CR 2-Circuit 7-Day Time Switch

[DiSteven]

Certainly! Here's a simplified guide to installing your INTERMATIC ET2725CR Electronic 2-Circuit 7-Day Time Switch:

1. Safety First: Always disconnect power at the circuit breaker or disconnect switch before beginning any installation work.
2. Bonding: If your enclosure is plastic, remember that bonding between conduit connections isn't automatic; you'll need to provide it during installation.
3. Wiring: Use #14 to #8 AWG wires, rated at least 105°C, and use COPPER conductors only. Strip 1/2 inch off the supply and load wires. Tighten the wires to 15.6 lbf-in.
4. Mounting: Choose a suitable location for the time switch and securely mount it using the provided mounting holes.
5. Connecting Wires: Connect the wires to the correct terminals on the time switch. Refer to the wiring diagrams in the manual for guidance. Tighten the screws firmly.
6. Grounding: If you have a metal enclosure, connect the ground wire to the grounding terminal, typically found at the bottom.
7. Insulator: Ensure there's no wire insulation under the terminal plate on the time switch connector. Put the insulator back in its original spot.
8. Close the Enclosure: Securely close the time switch enclosure door. Make sure it stays closed except when you're servicing it.
9. Apply Power: Once everything is connected and secure, restore power to the time switch. It should then be ready to use.

Remember, these are general instructions. For your safety and to ensure correct installation, always consult the specific instructions in your INTERMATIC ET2725CR Electronic 2-Circuit 7-Day Time Switch Instruction Manual.