How do I wirelessly trigger my Nikon camera flash using the PIXAPRO ST-IV+ 2.4GHz Wireless Trigger?

[FinleyLee]

Setting up your PIXAPRO ST-IV+ 2.4GHz Wireless Trigger for wireless flash photography with your Nikon camera involves a few straightforward steps. The process varies slightly depending on your flash type (camera flash, outdoor flash, studio flash, or original flash) and the shooting situation. Here's a comprehensive guide: First, install two AA batteries into the trigger's battery compartment. Then, follow these steps for the appropriate scenario:

For Wireless Camera Flash Triggering:

1. Mount the transmitter (the part that goes on your camera) onto your camera's hot shoe.
2. Power on both the trigger and your camera.
3. Set the channel and group settings on the trigger to match your flash setup.
4. Configure your camera flash settings for wireless triggering.
5. Press your camera's shutter button to fire the flash.

For Wireless Outdoor Flash Triggering:

1. Mount the transmitter on your camera's hot shoe.
2. Power on the trigger and the camera.
3. Set the channel and group on the trigger.
4. Configure your outdoor flash settings.
5. Press the camera shutter to trigger the flash.

For Wireless Studio Flash Triggering:

1. Mount the transmitter on your camera's hot shoe.
2. Power on the trigger and the camera.
3. Set the channel and group on the trigger.
4. Configure your studio flash settings.
5. Press the camera shutter to trigger the flash.

For Wireless Original Flash Triggering:

1. Mount the transmitter on your camera's hot shoe.
2. Power on the trigger and the camera.
3. Set the channel and group on the trigger.
4. Attach your original flash to the ST-III Receiver (if needed).
5. Press the camera shutter to trigger the flash.

For Wireless Shutter Release Triggering:

1. Connect the camera's shutter socket to the ST-III Receiver.
2. Set the channel and group on the trigger.
3. Configure the trigger mode and level parameters.
4. Set the trigger to "SHUTTER" mode.
5. Press the shutter button to focus and shoot.

For Flash Triggering Using the 2.5mm Sync Cord Jack:

1. Connect the sync cable between your camera and the ST-III Receiver.
2. Set the channel and group on the trigger.
3. Configure the trigger mode and level parameters.
4. Press the shutter to control the flashes.

For more detailed information and specific settings for your particular Nikon camera and flash setup, please consult the PIXAPRO ST-IV+ 2.4GHz Wireless Trigger instruction manual. This guide provides a general overview to get you started.