How do I turn on my ThinkWare Dash Cam after installation?

[LeFinn]

After installing your ThinkWare Dash Cam, the device is designed to power on automatically when your vehicle starts. Here's how to ensure it's properly connected and operating: For vehicles with combustion engines, with the ignition off, connect the IGN-3F cable to the 10-Pin Molex connector on the HWK-TW01-HAR. When the engine starts, the LED on the IGN-3F should change from flashing to solid, indicating power. For electric vehicles, find a switched accessory power receptacle (like a cigarette lighter). Connect the provided "T" harness in-line with the factory harness and the receptacle. Route the 10-pin Molex side of the "T" harness to the OBDII area and connect it to the corresponding connector. With the ignition off and the IGN-3F plugged in, the LED should flash slowly. It will turn solid when the vehicle starts, powering the dash cam. Your ThinkWare Dash Cam will start automatically when the vehicle is turned on and will stay on during start/stop sequences. It will turn off approximately two and a half minutes after the vehicle is shut down. If you need further assistance, please contact Echomaster at [e-mail] or call [phone].