How do I swap accessories on my Hi-Spec DM-170 Rotary Tool Kit?

[SanRyder]

Switching accessories on your Hi-Spec DM-170 Rotary Tool Kit is straightforward. Follow these steps:

1. Safety First: Always unplug the rotary tool before changing any accessories to prevent accidental starts.
2. Locate the Collet: Find the collet at the front of the tool. The collet secures the accessories.
3. Choose the Right Collet: Select the correct collet size (1.5mm, 2.3mm, or 3.2mm) for your accessory. The collet size must match the accessory's shank diameter.
4. Insert the Collet: Insert the collet into the chuck, aligning the flat sides of the collet with the flat sides of the chuck. Push it in until it's fully seated.
5. Select Your Accessory: Choose the accessory you need, like a sanding band or grinding stone.
6. Insert and Secure the Accessory: Place the accessory into the collet and tighten the collet nut clockwise to secure it. Ensure the accessory is firmly held.
7. Removing an Accessory: To remove an accessory, loosen the collet nut by turning it counterclockwise. Then, remove the accessory from the collet.
8. Repeat as Needed: Repeat these steps for each accessory change, making sure the collet is properly inserted and tightened.

Always prioritize safety when changing accessories and using your rotary tool. Consult the Hi-Spec DM-170's owner's manual for additional safety information and operational instructions.