To connect your Cyber Acoustics CA-2016WB speakers to your computer and start enjoying audio, follow these straightforward steps:
- Begin by ensuring the power switch on the Cyber Acoustics speakers is in the "off" position.
- Locate an available USB port on your computer or a USB hub.
- Carefully plug the USB connector from the speakers into the USB port on your computer or hub.
- Before turning on the speakers, make sure the volume control on the speakers is set to the minimum level, which is usually achieved by rotating the dial fully counterclockwise.
- Press the power button located on the front panel of the right speaker. The "power indicator" light should illuminate, signaling that the speakers are powered on.
- To verify the connection and audio output, play music or any audio from your computer or smartphone.
- Gradually increase the volume using the control on the speakers until you reach your desired listening level. Remember, it's often best to set the software volume or mixer on your computer to around 80-85% for optimal volume output.
- If you wish to use headphones, you can easily plug them into the headphone jack located on the front of the speaker. The speaker's volume control will then adjust the headphone volume.
Important Note: The speakers must remain connected to a USB port for power. If you experience any issues, consult the troubleshooting section in the Cyber Acoustics CA-2016WB user manual, or reach out to Cyber Acoustics customer support for additional assistance.
