Setting up and operating the Advanced Amplifiers AA-1M6G-30 Solid State RF Amplifier System requires careful attention to detail. Here's a comprehensive guide:
-
Incoming Inspection:
- Before you start, inspect the unit for any external damage or missing parts.
- Make sure all front and rear panel connectors are in good condition.
- Check the fans and airways to ensure they are clear of any obstructions.
-
RF & AC Cable Connections:
- Use the specified RF input and output connectors as detailed in the product manual.
- Use the provided AC power cable, or one with an equivalent or higher power rating.
- Refer to the front and rear panel descriptions to locate the RF and AC connectors.
-
RF Turn On Procedure:
- Connect the RF input to an RF Pulse Generator and the gating signal.
- Attach a suitable load to the output connector.
- Turn on the AC switch; the display should show "STANDBY."
- Optionally, connect the unit to a digital control software or via an Ethernet connection.
- Set the RF generator to 0dBm and the desired frequency within the specified range.
- Select Gain or ALC and set the desired output power level, then press the ONLINE button.
- Adjust the output power to the desired levels using the front panel controls or remote function.
-
RF Turn Off Procedure:
- Reduce the RF drive from the generator to below -20dBm.
- Press STANDBY on the LCD or through the control software.
- Turn off the AC switch on the front panel.
- Disconnect any unnecessary cable connections.
-
Safety Instructions:
- Ensure proper grounding and connection to a reliable safety ground.
- Connect the RF output connector to a load before turning on the AC switch.
- Always turn off both AC and RF power before disconnecting the output load or other components.
- Keep all air inlets and outlets clear to ensure optimal performance of your Advanced Amplifiers AA-1M6G-30 RF Amplifier.
