Setting the temperature and timer on your lbX instruments HDB Digital LED Dry Bath is straightforward. Here's a step-by-step guide:
-
Setting the Temperature:
- Ensure the operating voltage matches the power supply.
- Place your sample in a test tube on the work plate.
- Plug in the power and turn on the "POWER" switch.
- Use the Temperature (T º) button and the adjustment controls (as described in the user manual, the specific controls are not specified here) to set your desired temperature. The screen will display the set temperature.
- Press the parameter setting button (specific control is not specified here) to initiate heating. The Heat LED (yellow light) will illuminate, indicating the device is heating.
-
Setting the Timer:
- The device can operate in either timed or continuous mode.
- To set the timer, press the Timer button. The time display will flash, showing the previous setting.
- Use the parameter setting controls (specific control is not specified here) to adjust the time in minutes, then save your selection. The timer will begin counting down.
- To stop the timer during operation, press the speed/timer control (specific control is not specified here). Press it again to restart the countdown. The unit will stop automatically when the timer reaches zero.
-
Important Notes:
- Always set the working temperature before setting the timer.
- If the device doesn't start or reach the set temperature, check the power line, fuse, and control panel. If issues persist, contact the manufacturer or your supplier for assistance.
