To properly wire and ground your HINKLEY 2688 24-inch Black Outdoor Wall Mount Lantern, follow these steps:
-
Mounting Plate Setup: Detach the mounting plate from the backplate by removing the screws on the sides. Affix the mounting plate to the junction box on the wall using two 8-32 screws (not included). Make sure the plate is aligned correctly and plumb, adjusting as necessary. Pass the wires from the junction box through the center slot of the mounting plate.
-
Fixture Installation: Use the inspection cable on the backplate to hang the fixture onto the installed mounting plate. Connect all wires as per the instruction sheet (IS-18). Place the backplate over the mounting plate, aligning the holes and securing it with the screws you removed earlier.
-
Glass Installation: Remove the screws under the roof to detach the cage. Unscrew the glass clip to take out the glass and remove any packing material. Put the glass back into the fixture, securing it with the glass clips and screws. Install the light bulbs and then reattach the roof.
-
Wiring and Grounding Guide: Connect the positive and negative supply wires to the fixture leads, following the instructions for indoor or outdoor fixtures. For outdoor fixtures, use silicone sealant to create a waterproof seal over the connectors. Ground the fixture based on the specific instructions provided for your fixture type (flush mount, chain hung, or post-mount).
-
Caulking Procedures: Once the fixture is secured, seal the gap between the wall and the fixture's backplate with waterproof caulk or silicone sealant. Apply a small bead of caulk or sealant under the ball knobs used for mounting and seal the gap between the mounting top and fixture base. These steps ensure a safe and properly functioning HINKLEY 2688 outdoor wall mount lantern.
