
Programming the remote for your Hunter Pacific Creation v2 ceiling fan is straightforward. Here's a step-by-step guide:
Handset Installation/Replacement: Open the battery compartment on the remote. Remove any plastic wrapping from new batteries, noting the polarity for correct installation. Replace the cover.
Adding a Replacement Handset: Switch off the power to the fan at the wall switch, wait 30 seconds, then turn it back on. Press and hold the "Forward/Reverse" button on the remote until you hear a beep from the receiver. The remote is now linked.
Adding an Accessory 240V DC Wall Controller (sold separately): Turn off the power to the fan at the wall switch, wait 30 seconds, and turn it back on. Press and hold the "Forward/Reverse" button for 5 seconds until the fan beeps once. The wall controller is now linked.
Important Notes:
For any further issues, consult your Hunter Pacific Creation v2 ceiling fan manual or contact Hunter Pacific's technical support.


