Installing your WAREHOUSE WMG Dimmable and CCT Tunable wall pack light fixture is straightforward. Here's a guide to help you mount it correctly:
-
Mounting Options: This wall pack can be mounted directly to a recessed junction box or directly onto a wall. Note: Do not install it upside down or on the ceiling.
-
Separate the Front Cover: Begin by separating the front cover from the rear housing. You'll need to disconnect the wires connecting the driver and the PCB board to do this.
-
Locate Mounting Points: On the back of the rear housing, you'll find pre-cast locators designed for lag-bolt surface mounting.
-
Prepare the Housing: Use a hammer and punch to knock out the appropriate mounting holes. Refer to Figure 3 or Figure 4 in the manual for the correct holes.
-
Attach Conduit: Remove the threaded plug to allow conduit entry. Attach your conduit and secure the fixture to the wall.
-
Wire Connections: Consult the wire connection diagrams provided in the manual (Figure 6.1, 6.2, 6.3, or 6.4). Make sure to connect the ground wire from the front cover to the ground wire in the rear frame.
-
Seal Unused Entries: Ensure that any unused conduit entries are securely plugged to prevent water or debris from entering.
-
Final Checks: After installation, double-check that the fixture is firmly mounted and all wires are correctly connected. Turn on the power and verify that the light functions properly. If you encounter any issues, turn off the power and contact your local dealer for assistance. Following these steps will help you properly install your WAREHOUSE WMG Dimmable and CCT Tunable wall pack light fixture.
