Installing the Concept BikeErg Toe Clips One Pair is straightforward. Here's a step-by-step guide:
-
Gather Your Tools: You'll need a 5/16 inch (8 mm) wrench and a flathead screwdriver. Please note that these tools are not included with your purchase, so ensure you have them ready.
-
Secure Your Bike: Position your bike in a stable manner. A bike stand is ideal, or you can place it on the ground with the rear wheel elevated.
-
Identify the Pedal: Determine which pedal you're starting with. Concept BikeErg Toe Clips are specific to either the left or right pedal, so make sure you have the correct clip for each side.
-
Remove Reflector (if applicable): If your pedal has a reflector, you may need to remove it. Use the flathead screwdriver to carefully pry off the reflector if necessary.
-
Align the Toe Clip: Take the toe clip and align it with the pedal. The curved portion of the toe clip should face towards the front of your bike.
-
Insert and Tighten Screws: Insert the screws that came with your toe clips into the holes on the pedal. Use the 5/16 inch wrench to tighten the screws. Ensure the toe clip is securely attached to the pedal.
-
Repeat for the Other Pedal: If you're installing toe clips on both pedals, repeat steps 3 to 6 for the other pedal.
-
Test the Installation: Once both toe clips are installed, give them a firm tug to verify they are securely fastened. Make any necessary adjustments or tighten the screws further if needed.
You've successfully installed your Concept BikeErg Toe Clips! Before each ride, check the tightness of the screws to ensure the toe clips remain secure. If you have any questions or concerns, please contact Concept2 directly at 800.245.5676 or info@concept2.com.
