To ensure safe and efficient operation of your Linmore LED AH1 Ace LED High Bay fixture, adhere to these guidelines during installation and wiring. Begin by consulting the provided instruction manual for detailed steps. First, installation must comply with the National Electrical Code (NEC) and all local regulations, performed by a qualified individual familiar with the product. Safety is paramount; ensure the fixture is properly grounded. Verify voltage compatibility with the fixture driver, and always use approved connectors for all electrical connections. Prioritize safety by wearing appropriate Personal Protective Equipment (PPE) when handling the fixture. Note that this fixture is not suitable for wet locations, corrosive environments, or use with thermal insulation. Before any installation or maintenance, completely disconnect power at the circuit breaker to eliminate the risk of fire or electric shock. Never perform maintenance or cleaning while the fixture is energized; allow the fixture to cool after disconnecting power. Always review the diagrams provided. For lighting controls, consult the driver wiring diagram. Any maintenance should only be carried out by qualified electricians. For any wiring, installation, or operational inquiries, contact Linmore LED directly at 559-485-6010 or via email at techsupport@linmoreled.com. Regarding wiring, follow the NEC and local codes, and remember to ensure the power is off at the circuit breaker. Follow the provided instructions for either suspension or stem mounting. Securely attach the chain or cable to the ceiling or building structure and make the appropriate wire connections. If you are using the PIR Occupancy Sensor, refer to the instructions for installation and programming using the remote control.
