
Installing your REELCRAFT WC7000 Series Welding Cable Reel involves a few straightforward steps. First, inspect the reel for any shipping damage and ensure smooth operation by manually turning it. You'll then configure the reel for your preferred cable dispensing direction (top, side, or bottom) by adjusting the guide arm bracket. Next, position the reel on your chosen surface – floor, wall, or ceiling – and secure it using four bolts (customer-supplied). To install the output cable, remove the outer nuts from the collector ring cover and strip 1 1/8” of insulation from the cable. Route the cable around the reel spool, avoiding the guide arm opening, and add protective tubing to the spool opening. Route the input cable through the spool, collector ring base casting, and strain relief, securing it between the clamp plates with the nuts/screws. Tighten the strain relief and replace the collector ring cover. Fasten the cable to the spool using a u-bolt and nuts. Before winding the cable, check for ground faults using an ohmmeter. Wind the cable onto the spool, adding a few extra turns to create tension. Finally, add a bumper to the cable at your desired location. Always consult the REELCRAFT WC7000 Series Welding Cable Reel instruction manual for detailed diagrams and safety information.


