How do I connect the remote and collar for my PATPET T710 training system?

[LeilaniFitz]

To link your PATPET T710 remote transmitter and receiver collar, follow these steps:

1. Turn off the Receiver Collar: Make sure the collar is off. Press and hold the power button for about 5 seconds until the light blinks. The light will then flash once per second for 6 seconds, showing it's ready to pair.

2. Choose a Channel: On the remote, use the channel button to select either Dog 1 or Dog 2.

3. Pair the Devices: Press and hold the TONE, VIBRA, or Shock button on the remote. The collar should beep and the light should flash to confirm pairing.

4. Test the Connection: Press the TONE button on the remote. The collar should beep to show it's working.

If you have a two-dog system and need to pair a second collar:

1. Switch Dog Channels: Use the Dog 1/2 button on the remote to switch between Dog 1 and Dog 2.

2. Test the Dog 2 Collar: Press any mode button on the remote to check if the Dog 2 collar responds. If it doesn't, you may need to repeat the pairing steps. Repeat the steps above to pair the second collar.