How do I configure the Xunison Hub D50 Home for Mesh Wi-Fi?

[DiColin]

To set up Mesh Wi-Fi on your Xunison Hub D50 Home for expanded coverage, follow these steps:

1. Connect the Cables:

   • Ensure the power cable is connected.
   • Connect an Ethernet cable from your internet source to the WAN port on the router. If setting up as a satellite, disconnect the Ethernet cable after setup.

2. Power On:

   • Press the power button to turn on the device.

3. Initiate Mesh Mode Pairing:

   • Locate the PAIR button on the Xunison Hub D50 Home.
   • Press and hold the PAIR button for 5-10 seconds to start the Mesh setup process.
   • Observe the LED indicator lights for status:
     • Solid Green: Mesh network is connected or operating normally.
     • Blinking Green: Gateway pairing in progress.
     • Blinking Orange: Satellite pairing in progress.
     • Solid Green: Pairing was successful.
     • Blinking Red: Mesh setup failed.

4. Verify Mesh Setup:

   • Check the LED indicators. A solid green light confirms a successful Mesh network connection.

By following these steps, you can easily configure your Xunison Hub D50 Home in Mesh mode, extending your Wi-Fi range and improving connectivity throughout your home.