How do I configure the address for my PAD200-DUCT duct detector?

[GabrielRose]

Configuring the address for your PAD200-DUCT duct detector is straightforward. You'll use the dip switches located on the device itself. The PAD series, including detectors and modules, utilizes a seven-position dip switch for address configuration, enabling addresses from 1 to 127. Here's how to set the address:

1. Each gray box on the dip switch signifies the switch is 'On,' while a white box indicates 'Off.'
2. By default, with all dip switches in the 'Off' position, the device remains unaddressed.
3. To set an address for your PAD device, adjust the dip switches to match your desired address configuration.

Consult the PAD200-DUCT manual for visual examples illustrating the dip switch settings for both addressed and non-addressed devices. Important safety steps before connecting to the SLC loop to avoid any system or device damage:

• Make sure power to the SLC is disconnected.
• Confirm correct field wiring installation on the module.
• Inspect field wiring for open or short circuits.