How do I configure encrypted communication using C4Line C4L2000G-TWP-P IP Ethernet Over Transceivers?

[VonRichard]

To establish encrypted communication across multiple C4Line C4L2000G-TWP-P IP Ethernet Over Transceivers, follow these steps. First, let's look at how to un-join a transceiver to prepare it for a new encrypted network group:

1. Power up the transceiver.
2. Press and hold the small 'Grp' button for about 15 seconds. The TWP and PoE LEDs will illuminate briefly and then turn off, indicating the transceiver is un-joined.

Next, to join transceivers into an encrypted network group:

1. Disconnect one transceiver from the existing group. Connect the new, un-joined transceiver in its place.
2. Press the 'Grp' button on the new, un-joined transceiver for about 2 seconds.
3. The PoE LED will begin blinking.
4. Press the 'Grp' button on any transceiver already part of your encrypted network group.
5. Both transceivers are now in Joining mode.
6. Within approximately 10 seconds, the TWP LEDs on both transceivers will blink continuously, confirming a successful join.

To add additional transceivers to your encrypted network, repeat the joining process:

1. Disconnect an existing transceiver.
2. Replace it with a new, un-joined transceiver.
3. Follow the Joining mode steps.

Following these steps ensures a secure, encrypted network group configuration with your C4Line C4L2000G-TWP-P IP Ethernet Over Transceivers, enhancing the security of your network.