
Installing the VISA LIGHTING CM1980-W Symmetry Ceiling Light in a sheetrock ceiling requires careful attention to detail. Follow these steps, referencing the instruction manual for complete guidance:
Prepare the Opening: Begin by creating a framed opening to accommodate the fixture. The recessed housing opening should be precisely 23-3/4" to properly support the light during installation.
Initial Fixture Setup: Remove the lens and trim frame. Secure the trim frame screws back into the recessed housing for later use. Then, remove the driver/wiring cover and lamp plate.
Secure the Fixture: Use mounting screws, inserting them through the slots in the recessed housing, to secure the fixture to the ceiling structure. Adjust the fixture so the bottom of the housing is positioned exactly 1-3/8" above the finished sheetrock surface.
Electrical Connections: Connect all necessary electrical wiring in compliance with your local electrical codes.
Complete Sheetrock Installation: Finish the sheetrock installation around the recessed housing. Carefully cut a circular opening for the trim frame, ensuring a diameter between 22-5/16" and 22-9/16".
Final Fixture Assembly: Reattach the LED lamp plate, securing it to the standoffs located inside the recessed housing. Reinstall the trim flange, making sure it extends from the face of the sheetrock by 1/16". Reattach the driver/wiring cover and the lens assembly.
Thermal Protector Installation (if applicable): If your kit includes a thermal protector, remove the tape and insert it into the designated hole in the housing until it clicks into place. Ensure the thermal protector does not make contact with the T-bar grid system.
Alternate Sheetrock Installation: For sheetrock installation, refer to Sheet 4 in the instructions, excluding the threaded rod support method.
By meticulously following these steps, you can successfully and safely install your VISA LIGHTING CM1980-W Symmetry Ceiling Light, ensuring correct alignment, optimal function, and a professional finish.


