How do I change the flash pattern on my cell2 OE9 Surface Mount lighthead?

[SanFernando]

Changing the flash pattern on your cell2 OE9 Surface Mount lighthead is straightforward. Here's how, according to the user manual:

1. Mounting Preparation: First, determine where you want to mount your lighthead.
2. Drilling: Use the supplied mounting foam pad as a template to mark and drill the necessary holes.
3. Secure Installation: Fasten the lighthead to the mounting surface using the provided screws.
4. Flash Pattern Selection via the YELLOW wire: This is the key to pattern changes.
   • Momentarily apply positive voltage (+VDC) to the YELLOW wire. Each brief application cycles to the next flash pattern.
   • To jump directly to Flash Pattern 1 (FP#1), quickly apply positive voltage (+VDC) to the YELLOW wire three times.
5. Optimal Performance: For best results, mount the lighthead with the LEDs facing downwards.
6. Flash Pattern Options: The cell2 OE9 offers a variety of flash patterns:
   • 1: Single (2Hz)
   • 2: Double
   • 3: Triple (2Hz)
   • 4: Quad (2Hz)
   • 5: Random
   • 6: Steady
   • 7: Single
   • 8: Mega
   • 9: Double
   • 10: Triple
   • 11: Quad
   • 12: Quint
   • 13: 8 Flash
   • 14: Single-Quad
   • 15: Single H/L
   • 16: Single-Triple-Quint

By following these steps, you can easily customize your cell2 OE9 Surface Mount lighthead's flash pattern.